Jeep® BCI-CH21 User Manual

Loading ...

Pacic Accessory Corporation

| Ph. 866-931-8021 | [email protected]

www.pac-audio.com

Rev. 051915

Page 4

BCI-CH21

Navigation Unlock & Reverse Camera Input

Interface for Chrysler/Dodge/Jeep/Ram Vehicles

Pacific Accessory Corporation

DISCLAIMER: Under no circumstances shall the manufacture or the distributors of the BCI-CH21 be held liable for claims of any

loss or damage, consequential, direct or indirect, arising from the sale, installation, or use of the BCI-CH21. The manufacture

and its distributors will not, nor will they authorize any representative or any other individual, to assume obligation or liability in

relation to the BCI-CH21 other than its replacement.

AGREEMENT: End user agrees to use this product in compliance with the instructions and terms of use above and with all State

and Federal laws. PAC provides instructions and safety warnings with respect to this product and disclaims all liability for any use

not in conformity with those instructions or other misuse of its product. If you do not agree, please discontinue use immediately

and return product to place of purchase. This product is intended for off-road use and passenger use only.

Troubleshooting

1. Harness Loop - The loop in the BCI-CH21-HAR is a CAN termination

resistor that needs to be present on certain vehicles. If you have

followed the instructions for cutting the loop and your radio is not

coming on and the amber LED is blinking, you may need to re-connect

or cut the loop (depending on what you did initially).

2. The LEDs on the module can tell you what the BCI-CH21 is doing.

Please refer to the chart below for LED status patterns and possible

troubleshooting actions.

VES Mode & A/V Harness

LEDPattern State Action

Dualflashinggreen Initializing

Turnonignition

WaitforBCItofinishinitializing

Singleflashinggreen Active N/A

Singleflashinggreen,Solidamber Forcedreversecameraon N/A

SingleFlashingAmber NoCANcommunicationwithradio Changestatusofloop(cutorre‐connect)

SingleFlashingRed NoCANcommunicationwithvehicle

Checkharnessandconnectorpinsforproper

connection

LOAD

AUDIO

PULL

AUX

HARD DISC DRIVE

MP3•WMA•JPEG

VOLUME

MEDIA

RADIO

PUSH ON

RBZ

FILES

Activating VES Mode

1. Press the Media button on the factory radio

2. Press the “VES” icon on the screen

3. Press the “View Video” icon on the screen

4. This will display video and play audio that is fed in through the

group of RCAs labeled “Audio/Video To Head Unit” on the BCI-

CH21-AUX-HAR. PLEASE NOTE: If the vehicle is equipped with

an external VES Player, the RCAs labeled “Audio/Video To Head

Unit” will not allow an additional input to the head unit. You must

use the factory A/V aux in located in the rear of the vehicle.

5. If you want to feed more than one A/V source into the VES input,

an AVS-21 must be used.

6. The group of RCAs labeled “Audio/Video To Rear Screen” on the

BCI-CH21-AUX-HAR will only output A/V from the internal DVD

player. You can not make the radio output video from any other

source.

7. If the vehicle is equipped with a factory rear screen, an AVS-21

can be used on these RCAs to feed more than one A/V source to

the rear screen.

Loop

Jeep® BCI-CH21

User Manual - Page 4