Loading ...
Loading ...
32
SPECIFIC SAFETY INSTRUCTIONS
WARNINGS
Do not use the heater in areas where there is a risk of
explosion or fire from flammable gases. Ensure that the
heating area is kept clear of combustible materials. Do not
use the heater in damp areas, without suitable ventilation.
This heater is not designed for use within 1m or above a
water source. Do not place within one metre (1m) of any
water source. Do not place directly in front of, below or
above any power points or switches.
Fire risk exists if this heater is covered by or positioned
close to curtains or other combustible materials.
• This heater is intended for domestic/household use
only.
• Always ensure that this heater is installed as per
the requirements noted in Australian Standard
AS/NZS 3000:2007.
• Always keep heater at least one metre (1m) from
combustible materials.
• DO NOT locate this heater directly below, above or
in front of the power supply socket or switch.
• DO NOT use this heater within 1 metre or above any
water source.
• DO NOT use this heater in either the bathroom or
ensuite without suitable ventilation.
• DO NOT use a 3rd party timer, or programmable
system with this heater.
• DO NOT clean the heater while the heater is on or
plugged into the mains power supply.
• DO NOT touch any part of the heater while on, hot
surfaces may burn.
• DO NOT use the wall heater as a dryer.
• DO NOT attempt to modify the heater, power cord,
power plug or the supplied accessories in any way.
• DO NOT expose the heater to rain, water, or use in
damp wet conditions.
• NEVER cover this heater.
• NEVER carry the heater by its power supply cord.
• NEVER use with the power cord coiled, bundled up
or tied up. Always extend fully before use.
• NEVER use the heater if any part of it is damaged.
• Ensure that the heater is disconnected from the
mains supply when installing, cleaning or removing/
installing.
• Ensure this heater is not left on when unattended.
• Ensure the heater is not used in areas where
flammable gases are present, e.g. paint, petrol etc.
• Always turn the heater OFF at the unit switch and
the power point switch when not in use for extended
periods of time.
• Always allow the heater to cool, about one (1) hour
after the heater has been turned off, before cleaning
the heater.
• Always ensure that the power cord is fully extended
and NOT in contact with any part of the heater.
• Always ensure that the heater is kept clean and free
from dust.
• Only use this heater when securely attached to the
wall/ceiling.
Loading ...
Loading ...
Loading ...