Loading ...
32
Safety
Before attempting to operate this heater, the following
basic safety precautions should be taken to reduce
the risk of re, electric shock and personal injury. It
is important to read the instruction manual and to
understand its’ applications, limitations and potential
hazards associated with this heater. This heater is not
intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been
given supervision or instruction concerning the use of
the appliance by a person responsible for their safety.
This heater is not designed for use within 1m or above
a water source. It is important that you read, understand
and follow these instructions very carefully. They are
designed for the safety of yourself and others ensuring a
long and trouble free service life from your heater. This
electric heater complies with Australian and International
standards and safety requirements. Repairs should only
be carried out by qualied persons using original spare
parts. Failure to do so may result in considerable danger
to the operator.
SAFE OPERATION
Beware of Children and Pets
Children should not be allowed to touch or operate
heaters or touch extension cords, if used. All heaters
should be kept out of reach of children, preferably stored
or locked in a secure cabinet or room when not in use.
Do Not Abuse the Power Cord
Never yank or pull on the power cord to disconnect it from
the mains supply socket. Never carry your heater by its’
power cord. Keep the power cord away from heat, oil,
solvents and sharp edges. Check the power cord regularly
for any damage and if the power cord becomes damaged
have it replaced by an authorised service facility.
Extension Cords and Reels
This heater is NOT designed to run off an extension cord.
If you require an additional power point please have one
installed by a qualied electrician.
The use of extension cords may cause power voltage loss
which will result in damage to the appliance this will NOT
be covered under warranty.
Installation
Always ensure you select the correct xing accessories
which suit the particular wall/ceiling material you are
attaching to, if in doubt please discuss with your local
retailer or local hardware store. This heater is not
designed for use within 1m or above a water source.
All installations must meet the requirements of Australia
Standard AS/NZS 3000:2007.
Ensure that the heater is not positioned directly above,
below or in front of a power point or switch.
This heater is not designed to be used with 3rd party timer
or programmable system.
FOR YOUR SAFETY
WARNING: Fire risk exists if this heater is covered by
or positioned close to curtains or other combustible
materials.
NOTE: If using this heater outside ensure that it is
connected directly to an outdoor power point.
The electrical system of this heater must be
connected with an automatic 30mA circuit breaker
and/or residual current device (RCD). If uncertain
have a qualied electrician check your electrical
system before installation and/or use.
All electrical connections are made in a dry area.
Outdoor power points must be weatherproof and
installed by a qualied electrician.
Sitro Group Australia Pty Ltd is not responsible for
incorrectly chosen xing accessories or any damage
which may be caused by an incorrectly tted wall
heater.
If required 15AMP power points must be installed by
a qualied electrician.
For any queries or assistance call
Customer Service
Australia Only
1300 174 876
Hours of operation:
Monday to Friday 8am - 5pm AEST
Do not return to place of purchase.
Keep your purchase receipt, this will be required to
make any claims under the 12 month warranty.
INSTALLATION, OPERATION & MAINTENANCE INSTRUCTIONS
Loading ...
Loading ...
Loading ...