Loading ...
Loading ...
Loading ...
u
Each drawer can hold up
to 55.12 lbs (25 kg) of
frozen food; each plate
can hold up to 77.16 lbs
(35 kg).
5.7.9 Ice cube tray*
Fig. 10
When the water is frozen:
u
Hold the ice cube tray briefly under warm water.
u
Remove the lid.
u
Gently turn the ends of the ice cube tray in opposite
directions and release the cubes.
Dismantling the ice cube tray
Fig. 11
u
You can dismantle the ice cube tray for cleaning.
5.7.10 IceMaker*
The IceMaker is in the top drawer of the freezer compart-
ment.
Make sure that the following conditions are fulfilled:
-
The appliance is level.
-
The appliance is connected to the electricity supply.
-
The freezer compartment is switched on.
-
The minimum freezer temperature is 14 °F (-10 °C).
-
The IceMaker is connected to the water supply.
-
All air was bled from the waterline before starting the
icemaker. The icemaker will only work if there is no air
in the waterline.
Switching on the IceMaker*
Fig. 12
u
Pull out the drawer.
u
Press On/Off button
Fig. 12 (1)
so that the LED
Fig. 12 (2)
lights up.
u
Push in the drawer.
w
The IceMaker symbol
Fig. 3 (17)
shines.
Note
u
The IceMaker only produces ice cubes when the
drawer is completely closed.
Producing ice cubes*
The production capacity depends on the freezer tempera-
ture. The lower the temperature, the more ice cubes can
be produced in a certain period.
The production capacity is 90- 100 ice cubes in 24 hours
at a freezing temperature of 0 °F (-18 °C).
To have the maximum capacity of approx. 130 ice cubes
in 24 hours, activate the SuperFrost Function. Be aware
that this increases the energy consumption because the
compressor will run constantly.
The ice cubes fall out of the IceMaker into the drawer.
When the ice cubes reach a certain height in the drawer,
no more ice cubes can be produced. The IceMaker will
not fill the drawer to the top.
Evenly distribute the ice cubes in the drawer in order to
increase the filling capacity.
If large quantities of ice cubes are required, the complete
IceMaker drawer can be swapped with the neighboring
drawer. When you close the drawer, the IceMaker auto-
matically restarts production.
When the IceMaker is switched on for the first time, it may
take up to 24 hours for the first ice cubes to be produced.
Note
Particles may accumulate in the IceMaker or water line the
first time the appliance is used or after an extended period
out of service.
u
Do not use or consume ice cubes that are produced
within 24 hours of the first ice cube production.
Setting the water supply time*
The opening time of the valve on the IceMaker can be
adjusted if, for example, the water pressure in the pipe is
too low or too high.
The water supply time can be set in stages from E1 (short
supply time) to E8 (long supply time). The default setting
is E3.
u
Activate setting mode: press and hold the SuperFrost
button
Fig. 3 (9)
for approximately 5 s.
Operation
12 * Depending on model and options
Loading ...
Loading ...
Loading ...