Loading ...
Loading ...
Loading ...
6
CHANGING THE SHAPE OF THE FAN
A) Loosen the Collar 5201. Turn the Air Cap 5202 to the horizontal
position then re-tighten the Collar to lock it into place. This setting
produces a vertical spray pattern. This pattern is used more than any
other by experienced spray painters.
B) Setting the Air Cap in a vertical position produces a horizontal
spray pattern. To lock it in position, tighten the Collar. The horizontal
fan pattern is the most useful for painting vertically such as a
doorframe.
CHANGING THE SIZE OF THE FAN
To produce a smaller fan pattern, turn the Pattern Control Knob
5225 counter-clockwise. Because the spray pattern size is now much
smaller, you must turn down the amount of paint spraying through
the Nozzle at the Fluid Adjusting Knob 5221 (rear of gun). If you do
not do this, you will get runs.
To set the fluid output, simply turn the Fluid Adjusting Knob counter-
clockwise for more ‘paint’ and clockwise for less. Once you set the
fluid to your liking, you can leave it in this position - unless of course,
you change the size of the fan pattern.
For the very smallest pattern (less than 1”), you must move the Gun
closer to the workpiece - but don’t forget to reduce the amount of
paint at the Fluid Adjusting Knob.
19
GUN HOLDER & FILLING STATION
GUN HOLDER INSTALLATION
The 2 holes on the top of the Holder require the 2 Machine Screws and
Washers. These Screws fit into Threaded Inserts in the Metal Case. Do
not over tighten - snug is fine.
The single Silver-Colored Screw must be installed to the single hole on
the side of the Gun Holder. Once again, please do not over tighten this
screw - snug is fine.
If you do not intend on using the Gun Holder you may insert the appropri-
ate screws (as mentioned above) to block the holes.
GUN HOLDER USE
Place the Hose Connector 5229 (base of the Gun Handle) over the shaft
of the Gun Holder shown in above illustration. Please ensure it is fully set
down to the base of the shaft. The Spray Gun will now sit stationary. The
Gun can be left on the Holder for any length of time. It is a convenient
resting place between spraying and ideal for filling the Gravity Cup.
When spraying, always ensure that the Turbine unit is at least 15 feet
away from spray project and in a well ventilated area. This will prevent
any overspray or debris being ingested into the Turbine. Failure to do this
may cause the filters to clog, resulting in damage to the internal motor.
It is a good idea to make use of the Turbine Wireless Remote (Accessory
part # 3072). This device allows you to turn the Turbine unit on/off for your
convenience without having to walk back and forth to the Turbine.
If you experience a problem with your Turbine unit, please DO NOT try to
open and service the Turbine yourself. Contact us for technical assistance.
If it is an issue of no power, check your power outlet. Also, try re-setting
the Breaker on the back of the turbine by pressing it once.
Loading ...
Loading ...
Loading ...