Loading ...
Loading ...
Loading ...
Turn the switch to the “OFF” position and disconnect the
machine from power source before servicing or
disassembling any components.
CLEANING
• Keep machine and workplace clean. Avoid accumulation
of sawdust on the tool.
• Be certain motor is kept clean and free of dust.
• Use soap and water to clean painted parts, rubber parts
and plastic guards.
• Keep wheels clean. Debris on wheels will cause poor
tracking and blade slippage.
• Make sure blade brush is in contact with blade to
properly remove foreign particles from drive wheel.
LUBRICATION
• The shielded ball bearings are permanently lubricated
and require no further lubrication.
• Small amount of oil can be applied to belt tension
assembly and thread or sliding surfaces.
KEEP TOOL IN REPAIR
• I f power cord is worn, cut or damaged in any way, do
not operate the machine.
• Replace any worn, damaged, or missing parts. Use
parts listed to order parts.
• Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician.
• Call the customer line at 1-877-393-7121.
7
MAINTENANCE
7
WARNING
BEVEL CUTTING
• Beveled cutting is to tilt saw table for the desired degree.
• Loosen locking handle to unlock table.
• Rotate knob to tilt table to desired position.
• Lock table by tightening locking handle.
Loading ...
Loading ...
Loading ...