Loading ...
Loading ...
Loading ...
ADJUST BLADE GUIDES
Refer to Figure 9 to 11
• Blade guides should not be in contact with the blade
when not in operation.
• Adjust the blade guides after the blade tracking and
blade tension have been properly adjusted.
• The blade guide supports the blade with bearings on the
rear and guide pins on both sides. They all should be
adjusted to be 0.016” inches away from the blade. and
adjusted so that they are located just behind the set in
the teeth. For a quick gauge, fold a dollar bill in half
twice and place it between the blade and the guide pins
or the bearings. The thickness of 4x dollar bill is
approximately 0.016”.
• To adjust the guide pin position, loosen the screw on
each guide pin block. Secure the screws after
adjustment. Do the same for upper and lower blade
guides.
• Adjust the upper blade guide bearings position by
loosening the socket head bolt behind the bearings and
reposition the blade guide shaft. Tighten the bolt after
adjustment.
• Adjust the lower blade guide bearings position by
loosening the socket head bolt behind the bearings and
reposition the blade guide bracket. Tighten the bolt after
adjustment.
Figure 9
Figure 10
Figure 11
MITER GAUGE
Do not use miter gauge and rip fence at the same time.
Operator could be injured or/and the workpiece could be
damaged because the blade might bind in the workpiece.
• To adjust miter gauge, use a square with one edge
against the miter gauge face and the other against the
blade face.
• Loosen the lock knob on the miter gauge and adjust to
the right position.
• Tighten the lock knob and loosen the pointer screw and
adjust the pointer to 0° and tighten the screw on the
pointer.
BLADE WIDTH
• Blade width is the distance from tip of a tooth to back of
blade. The POWERTEC band saw blade width ranges
from 1/8” to 3/8”. Curve cutting of 1/8” radius needs the
blade width of 1/8”. Use blade width of ¼” for cutting
radius of 5/8”. Use blade width of 3/8” for 1-1/4” cutting
radius.
BLADE PITCH
• Pitch is the number of teeth per inch (TPI) or tooth size.
• More teeth per inch will cut slower but produce
smoother cutting surface; while fewer teeth per inch will
cut rougher but faster.
• For soft wood, the proper blade has between 6 to 8
teeth per inch.
• For hard wood, use a blade with 8 to 12 teeth per inch.
• Blade shocking occurs when pitch is too large and blade
tooth encounters too much material. This can trip teeth
from blade.
CONTOUR SAWING
• Contour cutting is guiding workpiece free-handed to
produce curved shapes.
• Turn the workpiece carefully so the blade follows
without twisting.
• Use a narrower blade to cut abrupt curves or make relief
cuts.
6
Socket Head
Bolt
Bearing
Screw
Bearing
Guide Pin
Socket
Head Bolt
Bearing
Screw
Guide Pin
WARNING
Loading ...
Loading ...
Loading ...