Troy-Bilt 52063 Troybilt high wheel trimmer

User Manual - Page 17

For 52063.

PDF File Manual, 24 pages, Download pdf file

Loading ...
Loading ...
Loading ...
I
_Sefore inspecting, cleaning or servicing the machine, shut off engine, wait for all moving parts to I
come to a stop, disconnectspark plug wire and move wire away from spark plug. Remove key on I
electric start models. I
Failure to follow these instructionscan result in serious personal injury or propertydamage. I
ThrottleControlAdJustment- If the
enginedoesnot shut off whenthethrottle
leveris movedto the stop position, or if
the enginedoes notrespondto various
throttle settings,referto the engine
manualfor serviceinformation.
0FF-SEASONSTORAGE
When storing the unit for extended
periods,follow these proceduresto
ensurethat the unit will be in goodcondi-
tion for future use.
Never perform maintenance when
engine isrunningor sparkplugwire is
connected,except when instructedto
do so.
Never store mower with fuel in fuel
tank inside a building where fumes
can reach an openflame or spark,or
where ignition sources are present
such as hot water and spaceheaters,
furnaces, clothesdryers,stoves, elec-
tric motors, etc. Make sure engine is
coolbeforestoring.
Drain gasoline outdoors into an
approvedcontainer.Donot smokeand
keepfuel away from openflame.
Failure to follow these instructionswill
result in serious personal injury or
propertydamage.
Store machineon alevelsurface.
Inspectfor any loose,broken or
missing parts. Repairor replaceparts
as needed.
Perform recommendedenginemainte-
nancebyfollowing the enginestorage
instructions found in the enginemanual.
Be sureto protect thefuel lines, carbu-
retor and fueltank from gumdeposits
by removing fuel or bytreating fuel with
a fuel stabilizer(follow enginemanufac-
turer's recommendations).
Cleananydirt, grass or chaff from the
air cooling system intakeareaand other
parts of the engine.
Onan electric startmodel, removekey
from keyswitch. Chargebatteryfor 24
hours beforeand after storage.
Disconnectspark plug wire andmove
wire awayfrom spark plug.
BATTERYSERVICE
BatteryRecharging
Rechargethe battery before and after
storing the unit for more than three
weeks.
Wet conditionscan cause an electric
shockhazardduring battery charging.
Avoidwet conditionswhen charging.
Rechargingthe battery with improper
equipment could cause a battery
explosion. Use only the battery
chargershippedtoyou. All partsmust
be fully stopped and the spark plug
wire disconnected and moved away
from thesparkplug.
Failure to comply could result in per-
sonalinjuryor propertydamage.
Theengine must be stopped and the area
in which rechargingwill take placemust
be dry.
1. Connectthe small receptacle(A,
Figure5-8) onthe batterychargercord to
the wire harness plug (B) located nearthe
keyswitch.
2. Plug therecharger box (C, Figure5-8)
into a grounded 120-Volt wall outlet.
3. Chargethe battery for 24 hours. After
charging, unplug the rechargerbox (C,
Figure5-8) from the wall outlet first, then
disconnect the recharging line plugs (A
and B, Figure5-8).
/
Figure 5-8: Userecharger suppliedwith
unit.
Battery Replacement
If the battery no longer takesa charge, or
if it is leakingor otherwise damaged,it
must be replaced.
1. Tilt thedebris shield forward.
2. Disconnectthe negative(-) blackwire
first; then the positive (+) red wire.
3. A clamp (D,Figure5-9), securesthe
batteryto thedeck. Removescrew (E),
then slidethe battery out from under the
clamp.
Figure 5-9: Batteryreplacement.
4. Position the newbattery underthe
clamp and replacescrew (E).
5. Connectthe red wire to the positive
(+) red-coded batteryterminal. Then,
connectthe blackwire to the negative(-)
black-codedbattery terminal.
NOTE:Discard battery properly, as
required by regulations in your area.
6. Closethe debris shield.
Loading ...
Loading ...
Loading ...