Loading ...
Loading ...
Loading ...
7
Installation
Level Refrigerator & Adjust Doors
(if necessary)
Guidelines for nal positioning of your refrigerator:
• All four corners of the cabinet must rest rmly on the
oor.
• The sides should tilt ¼ inch (6 mm) from front to back
(to ensure that doors close and seal properly).
• Doors should align with each other and be level.
Most of these conditions can be met by raising or
lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1. Slightly open freezer drawer if the toe grill is installed. Lift
the toe grille and gently pull forward.
2. Make initial cabinet adjustments by using the front roller
height adjusting screws. Use a 3/8 inch socket wrench to
turn the adjustment screws (1 per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.
3. Ensure both doors are bind-free with their seals touching
the cabinet on all four sides and that cabinet is stable.
4. After unit is leveled, lower anti-tip leg using a 3/8 inch
socket wrench until it rmly contacts the oor.
Raise
Lower
Anti-tip
Leg
Door
Door
5. Install the toe grill by tting into place.
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
To make nal door height adjustments:
1. Open freezer drawer to make lower hinge visible.
2. Insert 6mm Allen wrench into the shaft of the lower hinge.
3. Adjust the height by turning clockwise or counterclockwise.
Turning clockwise will lower the door. Turning
counterclockwise will raise the door. Default setting is to the
lowest height when you receive your appliance
Adjusting Flipper Mullion Screw
2. Adjust ipper mullion height. For proper connection with the
ipper mullion guide, there should be a separation about the
thickness of a coin (0.060 inches, or 1.5 mm) between the
guide and ipper mullion.
Adjusting Flipper Mullion Height
Raise
Your door handles may be different from those shown in the images
throughout this guide.
3. Re-tighten screw.
To adjust the ipper mullion:
1. Loosen the screw located on the ipper mullion hinge.
Loading ...
Loading ...
Loading ...