Loading ...
Loading ...
Loading ...
W415-1705 / 06.07.17
EN
46
finishing
11.7 optional blower installation
• Ensure the appliance is completely cool before starting installation.
• To avoid danger of suffocation, keep the packaging bag away from babies and children. Do not use in cribs,
beds, carriages or play pens. This bag is not a toy. Knot before throwing away.
!
WARNING
BLOWER
MOUNTING TAB
LOCATION
SCREW
LOCATION
H. Place the control module back into its original position. Ensure the transformer is plugged into the rear
outlet of the electrical box, refer to Figure 2.
I.
The variable speed switch (VSS) will need to be disassembled to secure to the VSS bracket for installation.
Place the VSS through the mounting bracket using the lock washer to secure it in place. Take the
variable speed switch knob and install into position. (Refer to Figure 6.)
J. To install the variable speed switch, the mounting bracket will first need to be installed. Remove the two
screws securing the piezo ignitor switch bracket in place, install the VSS mounting bracket into position
then reinstal the two previously removed screws, refer to Figure 6.
BLOWER
REAR VIEW
BLOWER
MOUNTING
TAB
A. Remove the safety screen by lifting it up and off of the appliance.
B. Remove the door from the appliance by releasing the door latches.
C. It may be necessary to move the control module aside during blower installation.
D. Attach the two 1/4” connectors (black and white) from the wire harness to the thermodisc.
E. Attach the two 1/4” connectors (black and red) from the wire harness to the blower.
F. Install the clear bumpers supplied onto the bottom of the blower to avoid the blower rubbing against the
floor of the appliance.
G. Pivot the blower into the bottom of the appliance, ensuring the gasket remains in place between the
blower and outer shell while sliding the blower against the back side of outer shell into the blower
mounting tab. Secure in place using one screw, see Figures 4 & 5.
NOTE: WITH THE ZIP TIE SUPPLIED, ENSURE ALL WIRES REMAIN CLEAR OF THE BLOWER.
K. Plug the connector from the variable speed switch to the matching connection on the wire harness.
L. For installation of the thermal disc bracket first bend the tab on the bottom of the firebox 90 degrees, this
will be the mounting tab for the thermal disc bracket, see Figure 7.
M. Bend the thermal disc bracket 90 degrees and secure it to the firebox mounting tab using the two screws
supplied, refer to Figure 7. Ensure that the thermal disc is in contact with the firebox base and that the
wire harness is properly attached.
N. Plug the power cord from the blower into the electrical box, refer to Figure 2.
NOTE: The blower is thermally activated, so when it is turned on, it will automatically start approximately
15 minutes after lighting the appliance and will run for approximately 30 minutes after the appliance has
been turned off.
FIGURE 6
VSS
BRACKET
PIEZO IGNITOR
BRACKET
FIGURE 7
THERMAL DISC
BRACKET
THERMAL DISC
MOUNTING TAB
FIREBOX BASE
FIGURE 5FIGURE 4
Loading ...
Loading ...
Loading ...