Loading ...
Loading ...
Loading ...
page 9
9. Light Kit Assembly (Optional). (cont.)
Connect male plug from switch housing to
female plug from light kit fitter. Make sure plugs
connect tightly.
Carefully arrange wiring in fitter plate and align
holes in switch housing with holes in fitter
plate. Re-insert screws that were previously
removed. Tighten all 3 screws with a Phillips
screwdriver.
Install 2 medium base 9-watt LED bulbs
(included).
IMPORTANT: When replacing bulbs, please
allow bulbs and glass shade to cool down
before touching.
Remove finial, finial plate and threaded washer
from threaded rod on light kit fitter.
Raise glass shade in order to guide pull chains
through corresponding holes. Align threaded
rod on light kit fitter with hole in middle of
glass shade and push up gently, allowing
threaded rod to come through hole. (Be sure
pull chain for fan operation does not rub against
bulb during operation.) Secure glass shade with
threaded washer.
Do NOT overtighten threaded washer as glass
may crack or break.
Align hole in center of finial plate with threaded
rod, allowing pull chains to come through
appropriate holes in finial plate, and push up.
Thread center pull chain through hole in finial
and re-attach finial.
Do NOT overtighten finial as glass may crack or
break.
fitter plate
threaded rod
motor
housing
male plug
female plug
finial
finial plate
glass
shade
threaded washer
reverse
switch
bulb
switch housing
light kit fitter
Loading ...
Loading ...
Loading ...