Loading ...
Loading ...
Loading ...
I CARPET/BARE FLOOR SELECTOR
Make sure vacuum cleaner isoff:
For longer belt life, turn vacuum cleaner off
before moving selector. Failure to do so
can cause the belt to rub on the selector
shaft and may result in the belt becoming
hot and creating a burning rubber smell.
Bare floor position:Rotatethe
carpet/bare floor selector all the way back
and down toward the bottom of the nozzle
until it locks into place.
ToBare Fl_or
Position I
Carpet/Bare
Floor Selector
in bare floor position the brush assembly
does not rotate. This setting should be
used for cleaning hardwood and tile
floors and when any attachments (tools)
are used.
J
_k CAUTION
Do not allow vacuum cleaner to remain
in one spat for any length of time when
the agitator is turning. Damage to carpet
mac occur.
i
Carpet setting position: Rotate the
selector all the way forward and up to the
carpet position.
In carpet position the brush assembly will
rotate. When carpets are being cleaned
the selector should be in this position.
Attention: Refer to your carpet
manufacturers cleaning recommendations,
Some more delicate carpets may require
vacuuming with the agitator turned off to
prevent carpet damage.
RELEASINGTHE HANDLE
Release the handle by pressing down on
the handle release pedal with your foot
and pulling back and down on the handle
with your hand.
Note: The agitator will rotate when the
vacuum cleaner is in the upright position.
ON/OFF SWITCH
To start the vacuum cleaner, slide the
ON/OFF switch from the OFF position to the
ON position. Tostop the vacuum cleaner,
slide the ON/OFF switch to the OFF
position.
o_
o_ _
Loading ...
Loading ...
Loading ...