Loading ...
Loading ...
Loading ...
6
ASSEMBLY INSTRUCTIONS
Black (hot)
White (neutral)
Bare/Green
(ground)
Black
Blue
White
Green
WARNING: Do NOT wire the
fan motor to a variable-speed
(dimmer) wall control.
Downrod
Canopy
Yoke Cover
Downrod Pin
Yoke
Downrod
Downrod Clip
Set Screw
Yoke
Tab
Slot
Downrod
Mounting
Bracket
7
5
6
5. Feed the wires coming from the yoke through the
yoke cover, canopy and downrod.
6. Insert the downrod into the yoke in the top of the
motor assembly and reinstall the downrod pin and
downrod clip. Then retighten the two set screws.
7. With wires extending out of the top of the downrod,
measure 8 inches of lead wire and cut the excess
wire with wire cutters (not included). Then strip 1/2”
of insulation from the end of each wire and lift the
downrod into the mounting bracket. Rotate the
downrod until the tab in the mounting bracket is seated
in the slot in the downrod ball.
WARNING: The fan and/or downrod should not rotate
in the mounting bracket if installed correctly. Failure to
align the slot in the downrod ball with the tab may result
in fan falling causing serious injury or death.
8
8. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the white wire from the fan to the white
(neutral) supply wire.
• Connect the black and blue wires from the fan to the
black (hot) supply wire.
• Connect the green wire from the fan and mounting
bracket to the bare/green (ground) supply wire.
Note: If a second hot/power wire is available from the
outlet box, connect it to the blue (light power) fan wire for
separate fan and light switches.
Important: After the connections have been made, the
wires should be turned upward and pushed carefully
up into the outlet box. Place the black and white wire
connections on opposite sides of the outlet box.
Wire Connector
Loading ...
Loading ...
Loading ...