Loading ...
Loading ...
Loading ...
8
• Visually inspect the exterior of the shipping package and immediately report any damage
to the carrier. Upon opening the package, any concealed damage should also be
immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. Remove the protective plastic
lm from the exterior panels on all models and from the interior door panels on solid
door models. If the appliance is exposed to the sun or to heat, remove the lm after the
appliance cools.
• Remove all accessory containers before discarding the packing materials. Dispose of all
packing materials in a proper and environmentally responsible manner.
• Check for missing or damaged accessories.
C. Setup
1. Remove the Appliance from the Pallet
1) Move as close to the nal location as
possible.
2) Remove the pallet end board(s). See Fig. 1.
3) Remove the bolts securing the appliance to
the pallet.
4) Secure the door(s) so that they will not
swing open during removal from the pallet.
5) While supporting the appliance to keep it
from tipping, slide the appliance off of the
pallet and lower the casters to the oor.
2. Install the Optional Overow Pan (if applicable)
An optional overow pan kit, HS-3521, is available for the unlikely event that water cannot
evaporate from the condensate pan at a high enough rate. To install the optional overow
pan, follow the directions below.
1) Attach the overow pan brackets by engaging the tabs on the brackets through the
holes in the bottom of the appliance and securing with the 4 mounting screws provided.
See Fig. 2.
2) Slide the plastic overow pan into place under the bushing on the bottom of the cabinet.
End Board
Door
Bolts
Fig. 1
Fig. 2
Overow Pan
Cabinet
Overow Pan
Tabs
Holes
Bushing
Cabinet
Overow Pan Brackets
Mounting
Screws
Loading ...
Loading ...
Loading ...