Loading ...
Loading ...
Loading ...
3-3
low-water sensor, such as when draining and cleaning the cookpot, the controller display will read
LO.
NORMAL WATER LEVEL SENSING, on units configured with the Autofill feature,
automatically adds water during or after a cooking cycle if the water in the cookpot drops to a level
lower than approximately 1¼-inch (32 mm) below the overflow drain. With this automatic filling
feature, the water level does not have to be continuously monitored. The cookpot always has the
correct amount of water.
FAHRENHEIT OR CELSIUS TEMPERATURE DISPLAY. There are two versions of the SMS
Controller: one that can be toggled between Fahrenheit and Celsius temperature display, and one
that cannot. To determine which version you have, turn the controller off by pressing the power
switch. The display will go blank. Press the Simmer button (right thermometer icon). If Code
appears in the display, the temperature display can be changed. If not, the display cannot be
changed.
1. If Code appears in the display, press 1, 6, 5, 8. The display will be toggled from Fahrenheit to
Celsius or from Celsius to Fahrenheit.
2. Press the Boil button (left thermometer icon) to display the cookpot temperature. If an F
follows the temperature, the display is in Fahrenheit; if a C follows the temperature, the display is
in Celsius.
3.3 Operating Instructions
Before turning the cooker on, ensure that:
• the unit is connected to the water supply.
• the water supply is turned on
• the unit is plugged in to an appropriate outlet.
• the electrical power supply is turned on
• the gas supply is turned on.
3.3.1 Start-up Procedure
CAUTION
If this is the first time the unit is being used after installation, refer also to
Section 3.3.3, Boiling Out the Cookpot.
1. Press the power switch to the ON position. If the cooker is equipped with the Autofill op-
tion, the cookpot will automatically begin to fill with water. If not, manually fill the cookpot us-
ing the faucet until the water level is above the upper water level sensor located at the left front
of the cookpot as you face the unit. (On units with Autofill, the water will automatically shut off
when the water in the cookpot has reached the correct level.)
2. Turn the gas valve knob to the ON position (see illustration at
right.)
Loading ...
Loading ...
Loading ...