Loading ...
Loading ...
Loading ...
2-7
2.5 Converting to Another Gas Type
DANGER
Your cooker is configured at the factory for a specific type of gas. If you desire to
switch from one type of gas to another, specific gas-conversion components must
be installed.
Switching to a different type of gas without installing the proper conversion
components may result in fire or explosion! NEVER attach your cooker to a gas
supply for which it is not configured.
Conversion of this appliance from one type of gas to another should only be
performed by qualified, licensed, and/or authorized installation or service personnel,
as defined in Section 1.5 of this manual.
Gas Conversion Components
Natural Gas to LP (Propane) Gas: LP (Propane) Gas to Natural Gas:
Orifice: 810-0386 (2 required)
Ignitor Kit: 826-0386 (2 required)
Regulator: 807-1848 (1 required)
Conversion Rating Label 802-2144.
Orifice: 810-0403 (2 required)
Ignitor Kit: 826-0981 (2 required)
Regulator: 807-1847 (1 required)
Conversion Rating Label 802-2144.
Gas Conversion Instructions
1. Change the orifices.
2. Change the ignitors.
3. Install the regulator kit in the gas valve in accordance with the instructions furnished with the kit.
4. Adjust the incoming gas pressure for the new gas. (Refer to the Standard for Incoming Gas
Pressure table on Page 2-5.)
5. Adjust the gas pressure at the gas valve regulator. (Refer to the Standard for Burner Gas Pres-
sure table on Page 2-6 and adjustment procedure in Chapter 4.)
6. Affix the new label included with the conversion kit next to the existing rating plate stating that
the gas type has been converted. Remove any references to the previously used gas from the
existing rating plate. Label PN 802-2144.
7. If the destination language changes, replace the labels. (You must contact your local service
agency or KES for a label kit. The language of reference is indicated on the corner of the label.)
Loading ...
Loading ...
Loading ...