Loading ...
Loading ...
Loading ...
7
English
Replacing the Saw Chain (Fig.A, F)
CAUTION: Sharp chain. Always wear protective
gloves when handling the chain. The chain is sharp
and can cut you when it is notrunning.
WARNING: Sharp moving chain. To prevent
accidental operation, ensure the tool is unplugged
before performing the following operations. Failure to
do this could result in serious personalinjury.
1. Rotate the chain tensioning screw
8
counterclockwise
to lessen chaintension.
2. Remove sprocket cover
6
as described in Installing the
Guide Bar and Saw Chainsection.
3. Lift the worn saw chain
5
out of the groove in the
guide bar
4
.
4. Place the new chain in the slot of the guide bar, making
sure the saw teeth are facing the correct direction by
matching the arrow on the chain with the graphic on
the sprocket cover
6
.
5. Follow instructions for Installing the Guide Bar and
SawChain.
Fig.F
2
Fig.E
Saw Chain and Guide Bar Oiling (Fig. A)
Auto Oiling System
This chain saw is equipped with an auto oiling system that
keeps the saw chain and guide bar constantly lubricated.
The oil level indicator
15
shows the level of the oil in the
chain saw. If the oil level is less than a quarter full, unplug
the chainsaw and refill with the properoil.
nOTE: Use a high quality bar and chain oil for proper saw
chain and bar lubrication. As a temporary substitute, a non-
detergent SAE30 weight motor oil can be used. The use of
a vegetable based bar and chain oil is recommended when
pruning trees. Mineral oil is not recommended because it
may harm trees. Never use waste oil or very thick oil. These
may damage yourchainsaw.
Filling the Oil Reservoir
1. Remove the oil cap
14
and fill the reservoir with the
recommended chain oil until the oil level has reached
the top of the oil level indicator
15
.
2. Refit the oilcap.
3. Periodically switch the chain saw off and check the oil
level indicator to ensure the bar and chain are being
properlyoiled.
Attaching Extension Cord (Fig. G)
An extension cord retainer
13
is built into the
switch handle. It prevents the extension cord from
comingunplugged.
• Double the extension cord and insert it into the slot
21
in the end of the handle area as shown in Fig. G. Hook
the loop formed by doubling the cord over the cord
retainer. Gently tug on the cord to ensure that it is firmly
retained in the handle. Plug the receptacle end of the
extension cord into the power cord
12
of thechainsaw.
Fig.G
13
21
12
Loading ...
Loading ...
Loading ...