Loading ...
Loading ...
Loading ...
.
Use a small paper clip to free any foreign material
clogging or restricting spray tip (A).
.
6,
Remove nozzleextension from spray gun.
Using a garden hose, remove additional debris by back
flushing water through nozzleextension. Backflush
between30 to 60 seconds.
7. Reinstaii spray tip into nozzleextension.
8. Reconnectnozzle extension to spray gun.
9. Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
10. Engagetrigger iock on spray gun and start engine
foliowing instructions How to Start Your Pressure
Washe,_
11. Test pressure washer by operating with each quick
connect spray tip.
g-Ring Maintenance
Purchasean O-Ring Repair Kit at your iocat Sears or by
calling 1-800-4-_I¥-NOME (469°4663) or online at
www.sears.com. The O-ring Maintenance Kit is not inciuded
with the pressure washer. This kit includes repiacement
o-rings, rubber washer and water inlet fiiter. Referto the
instruction sheet provided in the kit to service your unit's
o=rings.
WARNING
The high pressure stream of water that this
_ quipment produces can cut through skin and itsunderlying tissues, leadingto serious injury and
)ossible amputation.
o NEVERrepairleakingconnectionswith sealantof anykind.
Replaceo-ringor seal.
Pump 0il Maintenance
DONOTattempt any oii maintenanceon this pump. This
modei does not require any pump oii maintenance.The pump
is pre-Iubricated and sealed from the factory, requiring no
additional lubrication for the life of the pump.
ENGINEMAINTENANCE
WARNING
_ Unintentional sparking can result in fire or
_¢ electrb shock.
WHENADJUSTING(:INMAtqNGREPAIN$TOYOURPRESSUNE
W,_$NER
", Discormectthe sparkplugwire fromthe sparkplugandplace
thewire whereit cannotcontactsparkplug.
WNENTESTINGFeNENGINE$PARN
o Useapprovedsparkplug tester.
* DONOTcheckfor sparkwith sparkplugremoved.
0il
oimRecemmendatiens
NOTE:When adding oiI to the engine crankcase, use only
high quatity 4=stroke automotive detergent oii rated with APi
service classification SJ or SL rated SAE 10W=30weigilt. DO
NOTuse speciai additives.
1. Choosea viscosity according to table below.
-20 O 20 40 60 66 IO0°F
-30 -20 -10 0 10 26 36 40°C
AMBIENTTEMPERATURE
NOTE:Other viscosities shown in the chart may be used
when the averagetemperature in your area is within the
recommended range.
Checkin_lOil Level
OiI Ieveishould be checked prior to each use or at least every
5 hours of operation. Keep oii ievei maintained.
1. Piacepressure washer on a level surface and clean area
around oii dipstick.
2. Remove oii dipstick and wipe dipstick with clean cloth.
Insert and removedipstick without screwing it into the
filler neck.
Verify oii is at upper limit mark on dipstick. Replaceand
tighten dipstick.
OIL FILLER CAP/DIPSTICK
18
Loading ...
Loading ...
Loading ...