Loading ...
Loading ...
Loading ...
10
Before Operating The Drain Plug,Must Be
Water Temperature Adjustment
7. Turn on your water output device to the “on” position and adjust to the desired water flow.
8. There will be a series of audible clicks and the burner will ignite. Should the burner not ignite
after 5 seconds, shut off and go to the “Troubleshooting” section.
9. Upon completion of use or storage, open the drain valve (ribbed cylindrical stem next to the
water input valve) to ensure draining of water.
10. Turn off your gas supply.
11. WARNING: If the outside temperature is around or below freezing (32 ℉, 0℃),
ensure that the drain plug is opened and water drained from the portable tankless water
heater after each use to avoid internal damage to the heat exchanger. You will also need to
unhook the outgoing water line to ensure that any water in the heat exchanger is drained.
Failure to properly drain your portable tankless water heater will cause water damage
which may or may not be reparable.
1. Ensure that the water heater is disconnected from the gas supply.
2. Ensure that the water heater is disconnected from the water supply(turn off cold water inlet switch).
3. Turn the shower switch to "ON".
4. Ensure that the shower hose is disconnected from the water heater.
The temperature of the outgoing water is dependent on the temperature of the incoming water
balanced with the amount of heat applied. Use extreme caution in setting the outlet water
temperature.
1. With the water knob set to high, and the gas knob set to low, feel the outgoing water. This is
the lowest setting available.
2. To initially raise the outgoing temperature, slowly turn the gas valve towards maximum. Adjust
slowly and check the temperature often. There will be a slight delay between increasing the gas
supply and the increase in water temperature.
GAS INLET
BATTERY PACK
WATER OUTPUT WATER INLET
Loading ...
Loading ...
Loading ...