Loading ...
Loading ...
Loading ...
9
Please Check Prior To Continuing
Operation Instructions
before ignition as instruction. Make sure the gas inlet connector and water inlet connector are
screwed all the way on.
Tighten the fittings with use wrenches on both the brass adapter fitting on the appliance and the
brass connector on the end of the hose.
Check around area for flammables, especially gasoline or other vapors which may ignite. The
exhaust and top of the portable tankless water heater will get HOT! Make sure there are no
foreign objects around the portable tankless water heater or have fallen into the top.
WARNING: This model is intended for recreational & portable use only. This model
CANNOT be permanently mounted or plumbed in any way.
1. Turn on incoming water supply. Ensure that you have adequate water pressure of between 3.6-110
PSI.
2. Turn your water output device to its “off” position.
3. Turn the gas valve on the cylinder all the way open.
4. IF THE SMELL OF GAS IS DETECTED, TURN OFF THE GAS VALVE IMMEDIATELY!!
5. Set the water regulator knob on the face of the portable tankless water heater
to its highest setting.
6. Set the gas regulator knob on the face of the portable tankless water heater to its minimum setting.
● Attach the water output apparatus (shower head) to the fitting marked “Water outlet”. DO
NOT OVER TIGHTEN! Make sure to insert the supplied rubber gasket at the connections.
Tighten by hand only.
● Only use the pressure regulator & hose supplied with this appliance.
● Place at a comfortable height without putting stress on the gas hose. If the unit is to be
permanently mounted, use screws to attach the bottom tab firmly.
● Before opening LP cylinder valve, check the coupling nut for tightness. When appliance is not
in use, turn off LP cylinder valve on supply cylinder.
● Never use LP cylinder if visibly rusted, damaged or out of date.
● Clean and inspect the hose before each use of the appliance. If there is evidence of abrasion,
wear, cuts or leaks, the hose must be replaced prior to the appliance being put into operation.
*already attached to the gas inlet
Loading ...
Loading ...
Loading ...