Loading ...
Loading ...
Loading ...
www.usaprocom.com
17200159-01B
Log #1
Log #2
Log #3
Log #4
Rear Plate
PRESSURE TESTING HEATER GAS CONNECTIONS
INSTALLING LOGS
Figure 19 - Installing Log #1
Figure 20 - Installing Log #2
Figure 21 - Installing Log #3 & #4
Figure 18 - Stove Cabinet
INSTALLATION
1. Open equipment shuto valve (see Figure
15, page 16).
2. Open main gas valve located on or near
gas meter for natural gas or open propane
supply tank valve.
3. Make sure control knob of heater is in the
OFF position.
4. Check all joints from equipment shuto
valve to control valve (see Figure 16 or
17, page 15). Apply a noncorrosive leak
detection uid to all joints. Bubbles form-
ing show a leak.
5. Correct all leaks at once.
6. Light heater (see Lighting Instructions on
page 18). Check all other internal joints
for leaks.
7. Turn o heater (see To Turn O Gas Ap-
pliance, page 19).
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation,
and periodically thereafter,
check to ensure that no ame
comes in contact with any log.
With the heater set to high, check
to see if ames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
1. Install log #1 on the rear plate as shown
in Figure 19.
2. Install log #2 as shown in Figure 20.
3. Install log #3 and log #4 as shown in
Figure 21.
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
Loading ...
Loading ...
Loading ...