Loading ...
Loading ...
Loading ...
6
1.3 - Warranty
The Manufacturer is committed for 12 (twelve) months, from the date of shipping
and direct delivery of the goods, to guaranteeing the customer or authorised dealer
the integrity and good operation of the components relative to the machinery in
question.
The warranty excludes all parts of the machinery subject to normal wear, i.e
components in which use generates unstoppable constant wear:
A. Electric resistances – Teflon - Sealing gaskets – Dome opening pistons –
Sealing membrane– Air filters – Oil filters – Oil change – Pump vanes.
B. Whenever a vacuum pump relative to a machine under warranty is returned to
the Manufacturer due to problems regarding suction and malfunctioning, the
Manufacturer reserves the right to control whether foreign bodies have been
sucked up: (liquids, solids, juices, sauces etc.). If this situation is verified, the
repair materials and labour will be charged regularly, as the problem is not
linked to manufacturing defects but Customer negligence during use.
C. Any problems linked to the electronic circuit boards of the circuit must be
examined by the Manufacturer before the piece to be replaced is sent under
warranty. A voltage change, electric over-feeding, interference in the external
mains, could cause damage that is not the manufacturer’s fault or which can
be blamed on the manufacture of the piece.
D. Any problems linked to pneumatic, structural, mechanical parts, will be solved
normally under warranty without charge.
E. During the warranty period, for interventions covered by the same, there will
be no charge for the materials replaced, while labour costs will be calculated.
For any interventions performed during the warranty period that are not
covered by the warranty itself, the materials replaced and the labour will be
charged regularly.
F. If external interventions by our technicians are requested during the warranty
period, travel expenses (return) will be charged in full, independent of the
cause of the intervention.
1.4 - General recommendations and limits of liability of the
Manufacturer
Every operator-machine interaction, within the declared use ambit and the entire
life cycle of the same, has been carefully and thoroughly analysed by the
Manufacturer during the design and construction phases and when drawing up the
instruction manual. In spite of this, it is intended that nothing can replace the
experience, suitable training and especially the “good common sense” of those
interacting with the machine. The last requisites are therefore deemed
indispensible in every operational phase inherent the machine and when reading
this manual.
Failure to comply with the precautions or specific recommendations present in this
manual, use of the machine by unsuitable staff, violate all Safety Standards
concerning the design, manufacture and declared use of the supply and relieve the
Manufacturer from all liability in the event of damage/injury to objects/persons.
Loading ...
Loading ...
Loading ...