Loading ...
Loading ...
Loading ...
16
4 Using the machine
4.1– Control board key
1. ON-OFF Machine switch-on and access to the machine
programming menu.
2. Activation of inert gases (on machine set-up only)
Activation of thermal printer (on machine set-up only)
3. Increase times.
4. Decrease times.
5. - Selection of suction times (A).
- Selection of sealing times (B).
- Selection of gas injection time (C) (on machine set-up).
- Selection of automatic or saved programs (D).
6. Storing programs.
The current selection can be saved by holding this key
down until “program saved” appears on the display.
7. Analogue display for logo, programs, times, date and time.
A = suction time
B = sealing time
C = gas injection time
D = selected program
Button 1 pressed once when the machine is in vacuum mode, allows the bags to be sealed
immediately. If it is pressed twice, when the machine is in vacuum mode, it allows the
operator to run a quick discharge, instantly reopening the bell and avoiding the welding.
!!! CAUTION !!!
All the following functions and adjustments must be performed with the machine powered
(main switch ref. 8 fig. 4.1.2 in position ON)
and the board switched to OFF (the display will intermittently read OFF and the DATE and
TIME).
If the board is on, switch it off before you perform the following operations, by pressing the
key ref. 1 fig. 4.1.1
4.1.1 Adjusting the MENU language
Hold key 1 down (fig. 4.1.1) for at least 5 seconds.
“Languages” will appear on the display. By pressing keys 3 and 4 (fig. 4.1.1) the desired
language can be selected and then confirmed by pressing key 1 (fig. 4.1.1).
Fig. 4.1.1
8
Fig. 4.1.2
1 2 3 4
A B C D
5 67
Loading ...
Loading ...
Loading ...