Loading ...
Loading ...
Loading ...
The power tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect
tool from power source before making any adjustments or removing/installing
page 10
MAINTENANCE
attachments or accessories. Before reconnecting the tool, depress and release the
trigger switch to ensure that the tool is off.
Cleaning
WARNING: Blow dirt and dust out of all air vents with dry air at least once a week. Wear proper
ANSI Z87.1 (CAN/CSA Z94.3) eye protection and proper NIOSH/OSHA/MSHA respiratory
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse
any part of the tool into a liquid.
Lubrication
The tools are properly lubricated at the factory and are ready for use. Tools should be
relubricated regularly every sixty days to six months, depending on usage. (Tools used constantly
on production or heavy-duty jobs and tools exposed to heat may require more frequent lubrication.)
This lubrication should only be attempted by trained power tool repair persons o
r other authorized
service locations.
If you need assistance you can contact our customer service center at:
1-866-915-8626.
Motor Brushes
Be sure tool is unplugged before inspecting brushes. Carbon brushes should be regularly inspected
for wear. To inspect brushes, unscrew the plastic brush inspection caps (located in the sides of the
motor housing) so the spring and brush assemblies may be withdrawn from the tool. Keep brushes
clean and sliding freely in their guides. Carbon brushes have varying symbols stamped into them,
and if the brushes are worn down to the line closest to the spring, they must be replaced.
Accessories
WARNING:
Since accessories, other than those offered by MENARDS
®
, have not been tested with
this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury,
only
MENARDS
®
recommended accessories should be used with this product.
Recommended accessories for use with your tool are available at extra cost from your local dealer
or authorized service center.
Use only accessories having a maximum operating speed at least as high as the highest “NO LOAD
RPM” marked on the tool’s nameplate. This precaution applies to any accessory on any tool.
• 7" (180mm) hook and loop backing pads
• Wool ingestion shields
• Auxiliary handle
• Bale handle
•
Inner hexagon wrench
• Carbon brush
Loading ...
Loading ...
Loading ...