Loading ...
Loading ...
Loading ...
9
Operation (continued)
WHITE LIGHTS CONTROL
Press the HEATER and FLAME buttons
simultaneously to activate the rebox
white lights.
IMPORTANT: Under normal operation, when power is interrupted from either an outage of from
unplugging unit from wall while still in operation, error code “EC” may appear on the LCD control
panel and the unit will cease operation. In order to reset, unplug the unit for 10 minutes, then plug
back in for normal operation in accordance with the Use and Care guide.
Maintenance
DANGER: Disconnect power before servicing.
WARNING: Any electrical re-wiring of this appliance must be done by a qualied electrician. This
wiring must be done in accordance with local codes and/or in Canada with the current CSA C22.1
Canadian Electrical Code, and for US installations, the National Electrical Code ANSI/NFPA NO 70.
WARNING: If repairing or replacing any electrical component or wiring, the original wire routing, color
coding and securing locations must be followed.
GLASS INFORMATION
1. Under no circumstances should this product be operated with a broken or chipped glass panel.
2. Do not strike or slam the glass.
3. Do not use abrasive cleansers to clean the glass. Make sure the glass is cool to the touch.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done
by qualied/authorized service personnel only.
MAINTENANCE OF MOTORS
1. Always disconnect the appliance from the main power supply and allow it to cool before any servicing
operation.
2. The motors used on the fan heater and ame blower are pre-lubricated for extended bearing life and
require no further lubrication. However, periodic cleaning/vacuuming of the appliance around the air
intake and exhaust, as well as the fan heater is reccomended. For heavy or continous use, periodic
cleaning must be done more frequently. If the heater blows alternating cold and warm air, check the fan
for free movement and for debris restricting air ow. If the fan does not move freely, the unit be turned off
and fan replaced immiediately in order to prevent further damage to the unit.
REMOTE CONTROL INFORMATION
The infrared remote control relies on a line of sight and must be pointed
at the ame/screen of the replace to work. The remote control unit
has the controls required to turn ON/OFF both the main power and
the heater. If you prefer to use the touchpad control on the replace
unit itself, open the control panel sliding cover to access the touchpad
buttons. The layout of the buttons on touchpads and remote control
unit can be seen on the previous page.
The plastic tab inside the battery
compartment MUST be removed
before the remote control will operate.
(Pull Tab)
White lights Control:
Press the Heater and Flame Button at the same time
White lights turned OFF and ON
White lights Control:
Press the Heater and Flame Button at the same time
White lights turned OFF and ON
Loading ...
Loading ...
Loading ...