Loading ...
Loading ...
Loading ...
WARNING
To avoid possible SERIOUS INJURY from a falling garage door opener, fasten it SECURELY to
structural supports of the garage. Concrete anchors MUST be used if installing ANY brackets into
masonry.
Hanging the garage door opener will vary depending on your garage. Below are three example
installations. Your installation may be different. For ALL installations the garage door opener MUST be
connected to structural supports. The instructions illustrate one of the examples below.
1. On nished ceilings, use the lag screws to attach a support bracket (not provided) to the structural
supports before installing the garage door opener.
2. Make sure the garage door opener is aligned with the header bracket. Measure the distance from
each side of the garage door opener to the support bracket.
3. Cut both pieces of the hanging bracket to required lengths.
4. Attach the end of each hanging bracket to the support bracket with appropriate hardware (not
provided).
5. Attach the garage door opener to the hanging brackets with the hex bolts, lock washers, and nuts.
6. Remove the 2x4 and manually close the door. If the door hits the rail, raise the header bracket.
18
STEP 5 Hang the Garage Door Opener
EXAMPLES
1
Finished Ceiling
Finished Ceiling
Lag Screw
4
Not
Provided
Not Provided
Hex Bolt 5/16”-
18x7/8”
Lag Screw
5
Lock
Washer
Hex Bolt
Nut
HARDWARE
Lag Screw 5/16”-
9x1-5/8”
2
Nut
5/16”-18
Lock Washer
5/16”-18
Not Provided
6
3
Unfinished Ceiling
Installation
Loading ...
Loading ...
Loading ...