Loading ...
Loading ...
Loading ...
PACKAGE CONTENTS
PREPARATION
Fireplace body: 1pc Remote control: 1pc Touch up pen 1pc
Hardware Included:
Screw (M4x40): 2pcs Anchor: 2pcs Bracket: 1pc
Tools required (NOT included):
Phillips screwdriver Pencil Tape measure Hammer
1. The electrical outlet must be 120V AC / 60Hz. Make certain that the outlet is near the location
where electric fireplace is located so that the use of an extension cord is not necessary.
2. Avoid installing the electric fireplace in areas such as bathrooms, kitchen, or laundry rooms where
excessive moisture or water may be present. DO NOT place heater on carpet, near drapes or
materials that may easily catch fire.
3. Remove all parts and hardware from the carton and place them on a clean, soft and dry surface,
check the package content to make sure nothing is missing. Prepare the tools (NOT INCLUDED)
available before installation.
This tipping restraint strip is pre-assembled with fireplace, it must be attached to wall stud using the
screw provided.
1. Measure the fireplace height from the floor using a tape measure. Measure additional 1~2 inch
height above the fireplace height, mark on the wall where the fireplace will stand against with a
pencil. At the marked location on the wall, drill the appropriate holes for the anchors provided and
gently punch the anchors into the wall using a hammer. Attach the bracket to the wall with screw
(M4x40) using Phillips screwdriver and tighten clockwise (see Figure 2).
2. Place the fireplace into position so both mounting brackets are vertical in line.
NOTE: two adults are required to move the fieplace.
INSTALLATION
04
ON/OFFHeat
+
_
Flame
Timer
Heat OFF Downlight
TIPPING RESTRAINT KITS
Loading ...
Loading ...
Loading ...