Loading ...
Loading ...
Loading ...
53
2
Acc ess
Check the condition of the sunroof seals
regularly (presence of dust or deposits,
dead leaves, etc.).
If using a car wash, check that the sunroof
is correctly closed in advance and keep
the tip of the high-pressure lance at least
30 centimetres from the seals.
Never leave the vehicle with the sunroof
open.
Operation
When opening the sunroof fully, the movable
glass moves to a partially open position, then
slides over the roof. All intermediate positions
are allowed.
Depending on the speed of the vehicle,
the partially open position may vary to
improve the acoustics.
Opening and closing
F To open the sunroof or the blind, use the
part of the button located towards the rear.
F To close the sunroof or the blind, use the
part of the button located towards the front.
Operation of buttons
F Pressing a button beyond its point of
resistance directly opens or closes the
sunroof fully.
F Pressing the button down again stops the
current movement.
F If you hold a button (without going beyond
the point of resistance), the movement of
the sunroof or blind stops when you release
the button.
F When the sunroof is closed: pressing once
without passing the point of resistance
moves it to a partially open position.
F When the sunroof is partially open: pressing
once without passing the point of resistance
opens or closes it fully.
You can close the sunroof and windows,
then the blind, by pressing and holding the
door locking control. The movement stops
when you release the locking control.
Closing of the blind is limited by the
position of the sunroof: the blind cannot go
further than the front of the mobile glass.
During simultaneous movements of the
sunroof and blind, the blind automatically
stops or resumes movement depending on
the position of the sunroof.
Reinitialisation
Following reconnection of the battery or in
the event of a fault or jerky movement of the
sunroof or blind, reinitialisation is required.
F Check that nothing is interfering with the
sunroof or blind and that the seals are
clean.
F With the ignition on, fully close the sunroof
and blind.
F Press and hold the front part of button B,
until the sunroof and blind move slightly,
then hold for a further 1 second before
releasing.
F Wait 2 seconds and then press and hold
the front part of button B. The blind and the
sunroof will open and close, one after the
other. When both are completely closed
again, hold for a further 2 seconds and
release.
If there is an operating fault, restart the
whole procedure.
Loading ...
Loading ...
Loading ...