Loading ...
Loading ...
Loading ...
19
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | [email protected]
DANGER
Installing Natural Gas Connection To Grill
Refer to the diagram at the right and complete the
following steps:
1. Remove the natural gas hose from its shipping bag and
route hose under the heat shield.
Remove protective cap from the quick-disconnect
hose end, and route hose through hole in rear leg.
Reinstall protective cap onto quick-disconnect hose
end.
2. Position hose clamp (100) as shown in illustration at two
locations on rear leg.
3. Make sure hose runs evenly from the control panel, un-
der heat shield, and outward through rear leg.
4. Using two hose clamps as shown in illustration, secure
using fasteners provided with clamps; screw (101), lock-
washer (102), and hex nut (103).
Installing Natural Gas Hose
Natural gas hose must be routed under heat shield.
Failure to locate natural gas hose under heat shield will result
in a fi re or explosion which can cause serious bodily injury or
death, and damage to property.
Your natural gas grill is shipped with the natural gas
quick-disconnect hose preinstalled to the control
manifold. To complete assembly, the hose must be
routed under the heat shield and through the rear
leg.
Hose routed
under heat
shield.
Use Philips Screw (101),
Lockwasher (102),
& Hex Nut (103)
provided with clamp
Loading ...
Loading ...
Loading ...