Loading ...
Loading ...
Loading ...
14
Evo, Inc., 20560 SW 115th Ave., Tualatin, OR 97062 USA
Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | [email protected]
1. Install cooking surface to burner unit by centering locating
tab over burner skirt.
2. Tab Step must be positioned to outside of burner skirt to
allow cooking surface to be centered.
Gently move cooking surface right to left
and front to back to locate tabs to skirt.
Assembling Your Evo Grill
Drip Pan To Burner Unit
Cooking Surface To Burner Unit
Locating Tab
Tab Step
Tab Step fi ts to outside
of Burner Skirt
Some parts may contain sharp edges.
Wear protective gloves as necessary.
WARNING
Never attempt to install cooking surface when burners are
ignited. Failure to follow these instructions could result in
serious personal injury and property damage.
1. Lower drip pan over burner skirt with the round clean-out
hole of drip pan positioned on the left side of the control
panel. The three detent clips and waste container rails
must be facing downward.
2. Rest the drip pan on the three support brackets which
are riveted to the burner skirt
3. Position the three detent clips just before each support
bracket.
4. Grasp the drip pan with both hands across the diameter
and fi rmly rotate the pan to engage each detent clip onto
each of the three support brackets.
5. To remove drip pan, reverse the process of installation by
fi rmly rotating the drip pan counter clockwise.
NOTE:
Because drip pan detent clips are made of a stain-
less steel spring material, they are rigid when new
and it may be necessary to lightly pry each detent
clip from its mounting position in order to remove
the drip pan. Over time, as the clips are engaged and
disengaged, they will become easier to remove and install
with a fi rm rotation of the drip pan.
Always make sure waste tray is located on left
side of grill to allow drip pan detent clips to
properly engage the support brackets.
Loading ...
Loading ...
Loading ...