Loading ...
Loading ...
Loading ...
Adjusting the Sensor Head:
1. a: Aim sensor head (D) toward desired detection area, maintaining a 5° - 40° downward angle
to allow moisture to drain. (See Fig.1)
Note: Make sure sensor head is positioned with control knob facing towards the ground.
b: You can adjust the sensor head up and down to change the coverage area. Walk through
the detection zone at the farthest distance you wish to detect motion.
D
Adjustment Sensor Lower For Short Coverage
A
d
j
u
s
t
m
e
n
t
S
e
n
s
o
r
H
i
g
h
e
r
F
o
r
L
o
n
g
C
o
v
e
r
a
g
e
Fig.2-1
Fig.2-2
Fig.1
2. Range set too high may increase false triggering.
(See Fig.2-1, 2-2)
Fig.3
1. Gently grasp the light heads(C) and tilt them down, left or right to adjust the light
coverage area. Keep the light heads at least 1” (25mm) away from the sensor.
(See Fig.3)
Adjusting the Light Head:
C
ASSEMBLY INSTRUCTIONS (continued)
Page 4 of 17
191011
Sensitivity of Motion Sensor:
Fig. 4
Mode Sens Time
6H
Auto
3H
PC
L
M
H
Test
30s
3 min
1min
1. You can adjust the sensitivity of the motion sensor by using the “Sens” selector
located on the bottom surface of the sensor. (See Fig.4)
2. Adjust motion sensor sensitivity to HIGH (H), MEDIUM (M), or LOW (L) to achieve
desired performance.
3. Approximate range for each setting: 25 ft. (L), 45 ft. (M), 70 ft. (H).
Choose a mode by sliding the switch on the bottom of the sensor. (See Fig.4)
Note: When power is first applied, the light will turn on to 100% brightness.
The sensor will take 30 seconds to warm up.
1. TEST mode (daytime or nighttime operation ) (See Fig.4)
Then turns the light off about 5 seconds after motion is no longer detected.
2. AUTO MODE (nighttime operation only) (See Fig.4)
(30s/1min/3min). At dusk, the light turns on to low level brightness. When motion is detected, the light turns to full
brightness and stays on as long as motion continues. When the motion is no longer detected, the light stays on
high-level brightness for the predetermined time you set (30s/1min/3min), and then switches back to low level
automatically.
3. 3 HOURS (3H) MODE (nighttime operation only) (See Fig.4)
stays on as long as motion continues. When motion is no longer detected, it remains on for the predetermined
shut-off delay time you set (30s/1min/3min), and then returns to the low-level brightness automatically.
4. 6 HOURS (6H) MODE (nighttime operation only) (See Fig.4)
stays on as long as motion continues. When motion is no longer detected, it remains on for the predetermined
shut-off delay time you set (30s/1min/3min), and then returns to the low-level brightness automatically.
Loading ...
Loading ...
Loading ...