Loading ...
Loading ...
Page 3 of 17
ASSEMBLY INSTRUCTIONS (continued)
For eave mounted only:
Swing the sensor head towards the mounting bracket.
Controls
Mounting Bracket
Controls
Controls
Turn off the power at fuse or circuit box.
1. The fixture mounting bracket
(A) is pre-assembled on the
light fixture (B). Unscrew both
the decorative cover (DD)
and the fixture mounting
screw (EE) in order to remove
the mounting bracket (A).
2. Install the mounting strap
(CC) to the outlet box with
the stamped word “FRONT”
facing away from the outlet
box, using two mounting
screws (AA) that best fit the
outlet box. Mounting bracket
(A) should sit flush against
wall surface when secured.
(Choose one matching pair of suitable mounting screws
(AA) from the 3 pairs provided).
2
FRONT
CC
AA
A
3. Pull out the source wires from
the outlet box. Make wire
connections using wire
connectors (FF) as follows:
---Connect the black wire from
the fixture to the “hot” wire
from the power source.
---Connect the white wire from
the fixture to the neutral wire
from the power source.
Carefully tuck the wires back into the outlet box.
4. Place mounting bracket (A)
against the outlet box, insert
the mounting bracket screw
(BB) through the mounting
bracket hole, thread mounting
bracket screw (BB) into the
center hole of the mounting
strap(CC). Tighten the
mounting bracket screw (BB)
securely.
When mounting to a wall, the “UP” arrow must point
upward.
When mounting to an eave, the “UP” arrow must point
toward the building.
5. Attach the backplate(B) of the
light fixture to the mounting
bracket(A), secure it with the
fixture mounting screw(EE).
Then push the decorative
cover (DD) firmly into the
fixture mounting screw (EE)
hole on the light fixture.
6. With silicone caulking
compound, caulk
completely around where
the mounting bracket meets
the wall surface.
CAUTION: Be sure to
caulk completely where
the mounting bracket
meets the wall surface to
prevent water from
seeping into the outlet box.
Outlet Box
3
FF
4
FF
BB
A
CC
Outlet Box
6
1
A
B
DD
EE
5
A
B
DD
EE
Turn on the power at fuse or circuit box.
Ensure the indicator (E) is blinking red light.
If not, please press and hold the reset button (F) for 10 second and release to activate red light blinking.
191011
Loading ...
Loading ...
Loading ...