Loading ...
Loading ...
Loading ...
page 9
Electrical Extension Cords
CAUTION:
Use caution when using
extension cords.
Use an extension cord which is no more
than 25’ (7.6 m) long and at least 14 gauge.
Using an excessively long or thin-wired
extension cord will cause severe damage
to the motor.
PRE-OPERATION CHECKLIST
Before using the air compressor, refer to the
serial label for voltage and amperage
requirements. Make sure you have a sufficient
electrical supply for supporting the motor's
requirements.
Use a dedicated circuit for the best results.
Low voltage and/or an overload circuit can
cause the motor's overload protection system
circuit breaker to trip.
Use only a 3-wire extension cord that has
a 3- blade grounding plug.
As undersized cord results in a drop in the
line voltage and loss of power and
overheating.
When in doubt, use a heavier gauge. The
smaller the gauge the more current the
cord can carry.
Inspect all electrical extension cords to
ensure that they are free of damage.
When using an extension cord, use a
heavy-duty cord that is no more than 25 feet
long and at least 14 gauge. Use only a 3-wire
extension cord that has a 3-blade grounding
plug.
OPERATING THE AIR COMPRESSOR
WARNING:
This manual contains
important instructions for operating this
product. For your safety, and the safety of
others, be sure to read this manual
thoroughly before operating the product.
Failure to properly follow all the
instructive and precautions can cause you
and other to be seriously hurt or killed.
Save this manual for future reference.
This air compressor features a compact
structure, stable performance, high airflow
rate, and easy operation and maintenance.
Because the air compressor produces no oil
in the airflow, it can be used as an
independent air supply machine for situations
in which oil in the airflow is an issue. The
motor directly drives the pistons and is able to
function without lubrication for a long period
of time.
Introduction
1. Connect your air supply hose to a 1/4” male
universal or industrial quick connect coupler.
Connect the male quick connect coupler to
the female quick connect coupler located on
the air compressor
2. Make sure the drainage valve is off and that
the pressure switch is in the OFF position.
3. Ensure that the power supply you are going
to use is operating normally.
4. Insert the power supply cord into the power
supply socket.
Before using the air compressor for the first
time, complete a test run as follows:
1. Turn the power switch to the OFF position.
Plug the power supply cord into a power
supply socket. Start the air compressor by
turning the power switch to the ON position.
The pressure gauge reading will slowly rise
as pressure increases inside the air tank.
When the gauge reading reaches
115 PSI - 120 PSI, the pressure switch will
Assembly
Test Run
Loading ...
Loading ...
Loading ...