Loading ...
Loading ...
Loading ...
Page 16
FIG. 12
BEVEL CUTTING (FIG. 13)
1. Remove the battery pack from the tool.
2. Adjust the angle of cut to any desired
setting, between 0° and 56,° according
to the section “ADJUSTING THE
CUTTING ANGLE”.
3. Replace the battery pack.
4. Align the cutting line with the 45° blade-
guide notch on the base shoe when
making 45° bevel cuts.
5. Make a trial cut in scrap material along
a guideline to determine the amount to
offset the notch on the cutting material.
6. Hold the saw firmly with both hands.
7. Rest the front edge of the base shoe
on the workpiece without touching the
blade to the workpiece.
8. Start the saw and allow the blade to
reach full speed.
9. Guide the saw into the workpiece, and
make the cut.
10. Release the trigger switch and allow the
blade to come to a complete stop.
11. Lift the saw from the workpiece.
WARNING:
Attempting a bevel cut
without having the bevel-locking knob
securely locked in place can result in
serious injury.
FIG. 13A
45° Indicator
45° Indicator
Line of Cut
FIG. 13B
POCKET CUTTING (FIG. 14)
1. Remove the battery pack from the tool.
2. Adjust the bevel setting to 0° and tighten
the bevel locking knob.
3. Set the blade to the correct blade
cutting depth.
4. Replace the battery pack.
5. Use the blade-guard lever to swing the
lower blade guard up.
6. Hold the lower blade guard in place with
the blade-guard lever.
7. Rest the front of the base shoe against
the workpiece, with the rear of the base
shoe raised, making sure that the blade
does not touch the workpiece.
8. Press the lock-off button and depress
the trigger switch to start the saw.
9. Allow the blade to reach full speed,
then lower the saw into the material and
guide the saw into the workpiece and
make the cut.
OPERATION
Loading ...
Loading ...
Loading ...