Loading ...
Loading ...
Loading ...
Page 13
OPERATION
LED WORKLIGHT (FIG. 7)
The circular saw is equipped with a LED
worklight, which will illuminate when the
trigger switch is depressed. This provides
additional light on the surface of the
workpiece for operation in lower-light areas.
The light will stay on for 10 seconds after the
trigger has been released.
NOTICE: In the event that the saw
becomes overloaded or overheated,
the saw will stop and the LED will blink.
Remove the saw from the workpiece,
allow it cool, and then resume work.
FIG. 7
LED
Worklight
HOOK (FIG. 8)
Your tool is equipped with a convenient hook
for hanging your tool. To use, simply lift up
hook until it snaps into the open position.
When not in use for hanging, always lower
hook until it snaps into the closed position.
TO CHECK 0° BEVEL
STOP (FIG. 5)
1. Remove the battery pack from the tool.
2. Using a square ruler (available
separately), check the squareness of
the saw blade to the base of the saw.
FIG. 5
Square Ruler
Saw Blade
Base
TO ADJUST 0° BEVEL
STOP (FIG. 6)
1. Remove the battery pack from the tool.
2. Loosen the bevel-adjustment knob.
3. Use a hex wrench (available separately)
to turn the adjusting screw until the
base is square with the saw blade.
FIG. 6
Adjusting
Screw
Loading ...
Loading ...
Loading ...