Loading ...
Loading ...
Loading ...
Page 15
OPERATION
FIG. 10B
FIG. 10C
CROSS-CUTTING/RIP
CUTTING (FIG. 11)
When making a cross-cut or a rip cut, align
the guideline with the 0° indicator on the
base shoe. Blade thicknesses vary, so you
should always make a trial cut in scrap
material along a guideline to determine how
much the guideline must be offset from the
indicator to produce an accurate cut.
NOTICE: Use a guide when making long or
wide rip cuts.
FIG. 11
0° Indicator
Line of Cut
RIP CUTTING USING A STRAIGHT
EDGE (FIG. 12)
1. Secure the workpiece.
2. Clamp a straight edge to the workpiece
using C-clamps (available separately).
3. Press the lock-off button and depress
the trigger switch to start the saw.
4. Allow the blade to reach full speed, then
guide the saw into the workpiece and
make the cut.
5. Saw along the straight edge to achieve
a straight rip cut.
6. Release the trigger switch and allow the
blade to come to a complete stop.
7. Lift the saw from the workpiece.
WARNING:
Position the C-clamps
so that they will not interfere with the saw
housing during the cut.
WARNING:
Do not bind the blade
in the cut.
Loading ...
Loading ...
Loading ...