Loading ...
Loading ...
Loading ...
14
Pull light covers away from powerhead
Changing Light Bulbs
1. Disconnect power to door opener.
Open powerhead light cover(s) by pressing down on
upper locking tabs.
• Replace old light bulb(s) with new.
• Use 60 Watt MAX. incandescent bulbs or the CFL or LED
equivalent.
• Close powerhead light cover(s).
2. Reconnect power to door opener.
• Test light operation.
NOTE: Use of LED bulbs may reduce the range of your remote
controls. Visit www.GenieCompany.com for more information
and recommendations for LED bulbs.
Push down tabs
Pull light cover away from powerhead
F. Light Bulb Replacement
1 Light Models
2 Light Models
If excessive chain/belt sag is noticed below the rail:
1. Open the door until carriage is about mid travel and stop.
2. Disengage the carriage and manually close the door.
3. Loosen nuts on turnbuckle using 7/16” wrenches.
4. Rotate turnbuckle counter-clockwise until slack is removed from
chain/belt.
5. When measured on the opposite side of the rail from the
turnbuckle, a properly adjusted chain will have a 1/4” gap to the
bottom of the rail.
6. Tighten nuts to secure turnbuckle.
7. Be sure that chain/belt is not twisted or bound.
8. Manually open door to re-engage carriage to turnbuckle.
G. Chain/Belt Tension
1/4”
WARNING
!
• Use extreme caution when working from a ladder or step
stool or serious injury can occur.
• When replacing light cover, make sure wires are not pinched
or near moving parts.
• Use only properly rated incandescent, LED or CFL light bulbs.
• DO NOT use bulbs with a rating greater than 60 Watts.
• Use A19 size light bulbs. DO NOT use bulbs having a short
neck.
AVERTISSEMENT
!
• Faire particulièrement attention lors de travaux e ectués
depuis une échelle ou en escabeau.
• En referment le couvercle de l’éclairage, s’assurer que les ls
ne sont ni coincés ni près des pièces mobiles.
• Utilisez uniquement incandescence correctement classé, LED
ou des ampoules uocompactes.
• NE PAS utiliser des ampoules avec une note supérieure à 60
Watts
• Utilisez A19 ampoules de taille. NE PAS utiliser des ampoules
ayant un cou court.
MAINTENANCE & ADJUSTMENTS
* Genie LED light bulbs are designed to reduce or
eliminate reduced remote range issues caused by
common LED bulbs. They also o er better product
life by making them resistant to vibration caused
by the opener, and cold or damp weather. See
website for details at www.GenieCompany.com.
NOTE: SilentMax Connect™ models require a minimum 40
Watt or equivalent bulb, 60 watt maximum.
Loading ...
Loading ...
Loading ...