Loading ...
Loading ...
Loading ...
23
BURNER IGNITION - SNAP-JET GAS IGNITION SYSTEM
Burner Ignition –
Lighting with a Match
1. Rotate the RAPIDFIRE lid damper to the open
position(A).
2. Slide the bowl vent arm to the open position(B).
3. Maker sure that the burner control knob is turned
to the OFF ( ) position (C). Check by pushing
burner control knob in and turning it clockwise
until it stops.
4. Confirm that the cylinder is properly installed.
Refer to “INSTALLING THE LP CYLINDER.”
5. Open the grill lid (D).
m DANGER
Failure to open the lid before igniting the
grill’s burner, or not waiting five minutes
to allow the gas to clear if the grill does
not light, may result in an explosive flare-
up which can cause serious bodily injury
ordeath.
6. Refer to the “GRILLING METHODS” sections
for proper fuel grate placement and charcoal
placement. Position the charcoal on the fuel
grate.
7. Insert match into the matchstick holder (attached
to the inside of the door) and strike the match.
Insert matchstick holder with lit match under
charcoal next to the tip of the burner tube (E).
m WARNING: Do not place hand directly
above burner when match lighting.
8. Push burner control knob in and turn it slowly
counterclockwise to the on ( ) position (F).
9. Check that the burner is lit by observing aflame.
m WARNING: If burner fails to ignite within
five seconds, stop, turn the burner
control knob o, and wait five minutes
to allow the gas to clear before you try
again or light with a match.
m WARNING: Do not lean over the open grill
while igniting.
m CAUTION: Flame may be hard to see on a
bright day.
10. Turn the burner control knob to the the OFF ( )
position after 12-14 minutes if cooking directly or
indirectly. However, if smoking, turn the burner
control knob to the the OFF ( ) position after 7-10
minutes.
NOTE: The burner is only meant for igniting charcoal,
not for cooking. Turn burner control knob off promptly
after charcoal is lit to preserve the fuel in your
disposable cylinder.
A
D
C
F
E
B
Loading ...
Loading ...
Loading ...