Loading ...
Loading ...
Loading ...
W415-0297 / R / 02.23.21
EN
16
fi nishing
Replacement loose material must be purchased from
the original manufacturer. Application of
excess loose material may adversely affect the
performance of the appliance.
Log colours may vary. During the initial use of the
appliance, the colours will become more uniform as
colour pigments burn in during the heat activated curing
process.
Reinstall rod assembly and mesh curtain.
8.4 grate and log placement
Remove curtain mesh and rod assembly
Remove log carton
Remove grate from the lower control area (stored there when shipped)
Unscrew the 3 screws in the fi rebox, set grate in place and secure using the 3 screws that were just re-
moved.
Install the one piece log set by aligning the two holes on the bottom of the logs, with the two locating pins in the
fi rebox.
NOTE: PHAZER
TM
logs and glowing embers exclusive to Napoleon, provide a unique and realistic
glowing effect that is different in every installation. Take the time to carefully position the glowing
embers for a maximum glowing effect.
8.3 charcoal embers
Randomly place the charcoal embers along the front and sides of the log support in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
!
WARNING
• Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbon
deposits and delayed ignition.
• When supplied, charcoal embers, charcoal lumps and vermiculite are not to be placed on the burner.
note:
Charcoal embers are not to be placed on the burner.
!
WARNING
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly. Delayed ignition and carbon / soot distribution throughout the living area
may occur.
• The logs are fragile and should be handled with care.
• Do not place charcoal embers, vermiculite or charcoal lumps on this burner.
• All previously applied loose material (glowing embers) must be removed prior to reapplication.
• Do not change or substitute the glowing ember material provided with the appliance. If replacing, use only
replacement glowing embers available from your local authorized dealer / distributor.
• Failure to follow these instructions will adversely affect the appliance’s performance and may result in carbon
/ soot deposits inside the appliance and on surrounding surfaces.
Loading ...
Loading ...
Loading ...