Loading ...
Loading ...
Loading ...
12. Do not run the power tool while
carrying it at your side. Accidental contact
with the spinning accessory could snag your
clothing, pulling the accessory into your body.
13 Regularly clean the power tool’s air vents.
The motor’s fan will draw the dust inside
the housing and excessive accumulation of
powdered metal may cause electrical hazards.
14. Do not operate the power tool near
flammable materials. Sparks could ignite
these materials.
15. Do not use accessories that require
liquid coolants. Using water or other
liquid coolants may result in electrocution
or shock.
FURTHER SAFETY
INSTRUCTIONS FOR OPERATION
KICKBACK AND RELATED WARNINGS
1. Maintain a firm grip on the power tool and
position your body and arm to allow you
to resist kickback forces. Always use an
auxiliary handle, if provided, for maximum
control over kickback or torque reaction
during start-up. The operator can control
torque reactions or kickback forces, if
proper precautions are taken.
2. Never place your hand near the rotating
accessory. The accessory may kickback
over your hand.
3. Do not position your body in the area
where the power tool will move if kickback
occurs. Kickback will propel the tool in the
direction opposite to the wheel’s movement
at the point of snagging.
4. Use special care when working corners,
sharp edges etc. Avoid bouncing and
snagging the accessory. Corners, sharp
edges or bouncing have a tendency to snag
the rotating accessory and cause loss of
control or kickback.
5. Do not attach a saw chain woodcarving
blade or toothed saw blade. Such blades
create frequent kickback and loss of control.
ADDITIONAL SAFETY
INSTRUCTIONS FOR GRINDING
OPERATIONS
1. Use only wheel types that are
recommended for your power tool and the
specic guard designed for the selected
wheel. Wheels for which the power tool was
not designed cannot be adequately guarded
and are unsafe.
2. The grinding surface of centre depressed
wheels must be mounted below the plane
of the guard lip. An improperly mounted
wheel that projects through the plane of the
guard lip cannot be adequately protected.
3. The guard must be securely attached
to the power tool and positioned for
maximum safety, so the least amount of
wheel is exposed towards the operator.
The guard helps to protect the operator
from broken wheel fragments, accidental
contact with wheel and sparks that could
ignite clothing.
4. Wheels must be used only for
recommended applications. For example:
do not grind with the side of cut-off wheel.
Abrasive cut-off wheels are intended for
peripheral grinding, side forces applied to
these wheels may cause them to shatter.
5. Always use undamaged wheel anges
that are of the correct size and shape
for your selected wheel. Proper wheel
anges support the wheel thus reducing
the possibility of wheel breakage. Flanges
for cut-off wheels may be different from
grinding wheel flanges.
6. Do not use worn down wheels from larger
power tools. A wheel intended for a larger
power tool is not suitable for the higher speed
of a smaller tool and may burst.
SP
Page 7
SAFETY INSTRUCTIONS
Loading ...
Loading ...
Loading ...