Loading ...
Loading ...
Loading ...
SPECIFIC SAFETY RULES FOR
ANGLE GRINDER
1. To reduce the risk of electric shock or
damage to the charger and battery, use
only the batteries and charger listed.
Battery pack Charger
252-8024
252-8025
252-8036
252-8037
252-8044
252-8028
252-8029
252-8030
252-8031
252-8032
252-8033
252-8034
2. This power tool is intended to
function as a grinder. Read all safety
warnings, instructions, illustrations and
specifications provided with this power
tool. Failure to follow all instructions listed
below may result in electric shock, fire and/
or serious injury.
3. Do not use accessories that are not
specifically designed and recommended
by the tool manufacturer. Just because the
accessory can be attached to your power
tool, safe operation is not assured.
4. The rated speed of the accessory must
be at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their RATED SPEED can
break and fly apart.
5. The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled.
6. Threaded mounting of accessories must
match the grinder spindle thread. For
accessories mounted by flanges, the arbor
hole of the accessory must fit the locating
diameter of the flange. Accessories that
do not match the mounting hardware ofthe
power tool will run out of balance, vibrate
excessively and may cause loss of control.
7. Do not use a damaged accessory.
Before each use inspect the accessory
such as abrasive wheels for chips and
cracks. If power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run
the power tool at maximum no-load speed
for one minute. Damaged accessories will
normally break apart during this test time.
8. Wear personal protective equipment.
Depending on application, use a face shield,
safety goggles or safety glasses. As
appropriate, wear a dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments. The eye protection
must be capable of stopping flying debris
generated by various operations. The
dust mask or respirator must be capable
of filtrating particles generated by your
operation. Prolonged exposure to high
intensity noise may cause hearing loss.
9. Keep bystanders a safe distance away
from work area. Anyone entering the work
area must wear personal protective
equipment. Fragments of workpiece or
of a broken accessory may fly away and
cause injury beyond the immediate area
of operation.
10. Hold the power tool by the insulated
gripping surfaces only when performing
an operation where the grinding accessory
may contact hidden wiring or its own cord.
A cutting accessory contacting a “live” wire
may make exposed metal parts of the power
tool “live” and could give the operator an
electric shock.
11. Never lay the power tool down until the
accessory has come to a complete stop. The
spinning accessory may grab the surface and
pull the power tool out of your control.
Page 6
SAFETY INSTRUCTIONS
Loading ...
Loading ...
Loading ...