Loading ...
Loading ...
Loading ...
LuxProducts.com | 15
INSTALLATION WITH
P-BRIDGE4.
Step 4.1: Starting at your thermostat,
confirm that you have one of the system configurations below:
• Conventional 1H/1C (Y, G, W, R)
• Conventional 2H/1C (Y, G, W1, W2, R)
If you have a different configuration other than what is listed
above, please call LUX Technical Support for help with your
installation.
Step 4.2: Remove each wire from its terminal – make sure
that they do not fall down back into the wall.
Step 4.3: Remove the mounting screws from the base of the
old thermostat. Remove the base from the wall.
Step 4.4: If you would like to use the trim plate or wall
anchors, you can install them now.
Step 4.5:
Separate CS1 from its base, pull the halves apart from
the bottom edge. Pull the wires from your wall through the
center hole of the CS1 base. Secure the base
to the wall using the
included mounting
hardware
.
Loading ...
Loading ...
Loading ...