Loading ...
Loading ...
Loading ...
©2018 Hestan Commercial Corporation
16
EN
KEEP ANY ELECTRICAL CORD AND FUEL SUPPLY HOSE AWAY FROM ANY HEATED SURFACES.
1. To protect against electric shock, do not immerse cord or plugs in water or other liquid.
2. Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or taking
off parts.
3. Do not operate any outdoor cooking gas appliance with a damaged cord or plug, or after the appliance
malfunctions or has been damaged in any manner. Contact the manufacturer for repair.
4. Do not let the cord hang over the edge of a table or touch hot surfaces.
5. Do not use an outdoor cooking gas appliance for purposes other than intended.
6. Use only a Ground Fault Circuit Interrupter (GFCI) protected circuit with this outdoor cooking gas
appliance.
7. Never remove the grounding prong or use with a 2-prong ground adapter.
8. Use only extension cords with a 3-prong grounding plug, rated for the power of the equipment, and
approved for outdoor use with a W-A marking.
BURNER ADJUSTMENTS
Aspire side burners are similar to many residential gas cooktops. They do not have any adjustments, except
for the correct orifices, and adjustment of the low setting on the valve.
BURNER FLAME ADJUSTMENT
Each side burner is tested and adjusted at the factory prior to shipment. The proper orifice for the gas
type, and the air-fuel adjustment was made at this time. However, variations in the local gas supply,
the elevation where you live, converting from one gas type to another, and other factors might make it
necessary to adjust the burner flames.
The flames of the burners should be visually checked and
compared with the figures on the right.
Flames should be blue and stable with no yellow tips (LP units
will have some yellow tipping). There should be no excessive
noise or flame lifting. If any of these conditions exist, remove
the burner cap and check if dirt, debris, spider webs, etc., are
blocking the center venturi hole, or the individual burner
ports. The occasional orange flame that quickly goes away is
usually a small amount of dust or water condensation which is
burning off - this is normal.
VALVE ADJUSTMENTS
The valves on your Aspire side burner are preset at the factory for optimum performance. However, the
valve also features a low (simmer) adjustment if altitude, low-heat performance, converting from one gas to
another, or other factors indicate an adjustment is needed.
NEVER ADJUST THE BURNER SO LOW THAT IT MAY GO OUT DURING
USE. DO NOT OPERATE THE SIDE BURNER WITH THE LOW HEAT SCREW
REMOVED. GAS CAN ESCAPE AND CAUSE A POTENTIALLY HAZARDOUS
CONDITION.
GAS AND ELECTRICAL CONNECTIONS
(continued)
Loading ...
Loading ...
Loading ...