User Manual Remington MB6850-AT Vacuum Beard & Stubble Trimmer 6000

Documents for Remington MB6850-AT

The following documents are available:
User Manual Photos
MB6850-AT photo

Use and Care Guide

For MB6850-AT. Also, The document are for others Remington models: MB6850

VACUUM
Beard and Stubble
Trimmer
When using an electrical appliance, basic precautions should always be observed,
including the following. Read all instructions before using this appliance.
DANGER
To reduce the risk of electric shock:
Do not reach for an appliance that has fallen into water. Unplug it immediately.
Do not use while bathing or in the shower.
Do not place or drop into water or other liquid.
Do not place or store this appliance where it can fall or be pulled into a tub
or sink.
Except when charging, always unplug this appliance from the electrical outlet
immediately after using.
Unplug this appliance before cleaning it.
WARNINGS
To reduce the risk of burns, fire, electric shock or injury to persons:
This appliance is for household use only.
An appliance should never be left unattended when it’s plugged in, except when
charging a rechargeable appliance.
Close supervision is necessary when this appliance is used by, on, or near
children or persons with special needs.
Use this appliance only for its intended use as described in this manual.
Do not use attachments not recommended by the manufacturer.
Keep the cord away from heated surfaces.
Never operate this appliance if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or if it has been dropped into water.
If any of these things happen, return the appliance to an authorized service
center for examination and repair.
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Never drop or insert any object into any of the appliance’s openings.
Do not use outdoors or operate where aerosol (spray) products are being used, or
where oxygen is being administered.
Make sure the cord is disconnected from the trimmer while storing this appliance
and cord in a moisture-free area. Do not store it in temperatures exceeding
140°F (60°C).
Do not use this appliance with a damaged or broken cutter unit, as injury may
occur. Always make sure blades are aligned properly.
Always attach plug to appliance, then adapter to outlet. To disconnect, turn all
controls to OFF, then remove adapter from outlet, then detach power cord from
the trimmer for storage.
Do not use an extension cord or a voltage converter with this appliance.
Do not wrap the cord around the appliance.
Dispose of used batteries properly. Do not incinerate. Batteries may explode if
overheated. Do not wrap in metal or aluminum foil. Wrap in newspaper before
discarding. It is suggested that you contact local battery redemption site(s)
in your area.
MB6850
Use and Care Guide
1. Adjustable beard comb 2 – 18mm
2. Main blade
3. Vacuum intake
4. Vacuum chamber release buttons
5. Vacuum chamber
6. On/off switch
7. Charge indicator light
8. Charger connector
9. Detail blade
10. Comb lock button
Also Includes:
Charging adapter
Cleaning brush
KEY PARTS
CHARGING
Charge your trimmer:
Before using for the first time.
When the charge indicator light isashing.
After your trimmer has not been used for a long time.
1. Ensure the trimmer is switched off.
2. Connect the charging adapter to the charger connector and then to
the power outlet.
3. When charging, the charge indicator light will light up. The light will
go out when charging is complete.
4. A first-time charge should take approximately 2-4 hours. Top-up
charges should take approximately 2 hours.
To preserve the life of your batteries, let them run out every 6 months.
Then, recharge for 16-20 hours.
Corded/cordless use
When fully charged, your trimmer should provide approximately 60
minutes of cordless use.
You can also connect the charger (as if you were going to charge the
trimmer) and operate the trimmer ‘corded’ if desired.
ATTACHMENTS
Exchanging the main and detail blades
Your trimmer is supplied with the main blade already attached. It is easier to
remove and reattach the main blade with the vacuum chamber removed.
1. Switch your trimmer off.
2. Hold the trimmer in one hand.
3. Push the top of the blade away
from the trimmer body using your
thumb. (Fig A)
4. Use enough force to free the
blade from the trimmer body.
Once free, lift it off.
5. Attach the desired blade by engaging the tab on the back of the blade into
the rear of your trimmer. Press the front of the blade down until it clicks.
6. Replace the vacuum chamber.
PRODUCT FEATURES
Attaching/removing the adjustable beard comb
1. Switch your trimmer off.
2. Depress the comb lock button then slide the adjustable comb into the
guides on the rear of your trimmer. Slide the comb all the way down.
Then, release the button.
3. To adjust the length of the beard comb, depress the comb lock button
then slide the comb to the desired length)
INSTRUCTIONS FOR USE
THIS PRODUCT IS NOT SUITABLE TO USE IN THE BATH OR SHOWER.
Trimming your beard
For even cutting, allow your trimmer to cut its way through the beard hair. Do
not force it through quickly. If you are cutting for the first time, start with the
maximum comb length attachment.
Regularly check the level of collected hair in the vacuum chamber. When full,
switch off your trimmer and remove the vacuum chamber. Empty the hair
clippings. Reattach the vacuum chamber before continuing use.
Trimming or tapering the beard or mustache
1. Set the adjustable comb to the desired length.
2. Place the flat part of the comb against the skin. Slowly slide the comb
through the hair.
3. Repeat from different directions as necessary.
4. If hair builds up in the trimmer comb during the trimming process, switch
the unit off, remove the comb and brush off the hair.
Dening the line of the beard or mustache
1. Remove the main blade and replace it with the detail blade.
2. Start trimming at the edges of your beard/mustache line.
3. Move your trimmer carefully towards the line until the desired shape is achieved.
Trimming your sideburns
1. Attach the wide trimming head, or the detail trimming head, as required.
2. Hold your trimmer with blade facing you.
3. Start with edge of your sideburns. With the trimmer blade resting lightly
against your skin, move your trimmer carefully towards your sideburn until
the desired shape is achieved.
Register Your New Product Today!
By registering your new Remington
®
product, you will receive special offers.
Register online at: RemingtonProducts.com
Loading ...
Loading ...
Loading ...