Loading ...
Loading ...
Loading ...
WALL MOUNT
1. Install four AA-size 1.5V batteries into the remote receiver box (Fig 3). The system operates well with all
batteries’ total output voltage is greater than 5.2V. Generally, four NEW AA-size batteries should output voltage of
6.0 to 6.2 volts if installed in series.
2. Attach wall mount cover plate to receiver box (Fig. 6). Press the receiver and have it snap into top & bottom
tabs of cover plate.
3. Position the cover plate to have words facing up (Fig. 7) Install the remote receiver box into the wall switch
box with two provided switch box long screws.
NOTE: The remote receiver box will only receive signal from the transmitter in the REMOTE position (middle). The
remote receiver box code must be matched to the transmitter prior to initial use (see LEARNING TRANSMITTER TO
RECEIVER).
HEARTH MOUNT
The remote receiver box can be placed on the fireplace, under the fireplace, behind the control panel or louvers....etc.
Keep away from high-heat of exceeding 130°F. Additional protection is required for no exposure to the heat. The Slide
switch button should be installed on the receiver box for Hearth Mount (Fig. 8).
WIRING INSTRUCTIONS
ONLY qualified electrician / gas technician with the knowledge of gas appliances and gas valves that are permitted to
install the remote control system. Incorrect wiring installation will damage the gas valve, electronic module of gas
appliance and also the remote receiver.
Fig. 6
Fig. 7
Fig. 8
Page 4
Loading ...
Loading ...
Loading ...