Loading ...
Loading ...
ON mode: Slide the switch to the ON position (toward the LEARN button), the system will remain ON all the time.
Remote transmitter is disabled.
REMOTE mode: Slide the switch to the REMOTE position (middle), the system will ONLY operate with receiving signals
/ commands from the remote transmitter.
OFF mode: Slide the switch to the OFF position, the system will remain OFF all the time. Remote transmitter and
Receiver box are both disabled.
★NOTE: The OFF mode is strongly recommended if house is unattended for a long time. For safety, placing the slide
switch in the OFF position also functions as a safety “LOCK-OUT” by both turning the system off and disable the remote
receiver.
W
ARNING & REMINDER
This system MUST be installed exactly as complied with these instructions. Read all instructions before
installation, and follow them during installation carefully.
Any modifications of Durablow remote control system, or parts, or components are PROHIBITED. They will void
the warranty, and may cause a fire hazard result in human casualties and property damages.
Do NOT connect any gas valve or electronic module directly to 110-120VAC power.
Read gas appliance manufacturer’s instructions and wiring schematics completely for proper placement of all
wires. All electronic modules are to be wired to manufacturer’s specifications.
All wiring diagrams in these instructions are for illustration purpose ONLY. Follow instructions from manufacturers of
gas valve and electronic module for correct wiring & installation procedures. Improper installation of electric
components can cause damage to electronic module, gas valve and remote receiver.
PRE - INSTALLATION
Decide where to install the receiver box before proceeding. The receiver is designed to be wall-mounted into a standard
wall switch box (STRONGLY SUGGESTED).
Otherwise, you can place it under or near the fireplace hearth (*IMPORTANT: Keep away from high-heat of exceeding
130°F. Additional protection is required for no exposure to the heat).
Make sure the receiver box’s slide switch is in the OFF
position before installation.
The receiver is connected with 18-inches of black wire. If
additional length of wire is required, for the best results, 18
gauge stranded or solid wire are recommended. Splice with
the original black wires of the receiver box. Or, remove the
black wires and insert new wires directly into the slots at
back of receiver box (Fig, 5). Wires are NOT longer than 20-
feet. Please allow some wire / space to remove the receiver
for battery replacement or check.
Fig. 5
Page 3
Loading ...
Loading ...
Loading ...