Loading ...
Loading ...
Loading ...
– 11 –
6. Once the screws are loose, easily slide the
rip fence above, allowing you to close the
gap between the square and the rip fence.
When the square is flush against the rip
fence re-tighten the two ¼ inch bolts from
the side you are adjusting. If necessary,
repeat the same steps for the other side.
(See Image G)
IMAGE G
7. Once both rip fences are secured in place
slide the extruded aluminum angle bar firmly
against both rip fences and tighten in place
for additional support.
CUSTOMER SERVICE:
1-866-435-8665
5. From underneath the saw, directly below the rip
fence, there are two ¼ inch bolts located under
the left rip fence and 2 bolts under the right rip
fence. Loosen both bolts for the rip fence that
you are adjusting. (See Images E & F)
IMAGE E
IMAGE F
¼
"
Bolts
Loading ...
Loading ...
Loading ...