Loading ...
Loading ...
Loading ...
– 8 –
MAKING A DIAGONAL CUT
1. Follow the same procedure for a straight cut.
2. Loosen the nut on the squaring tool, and
position the tile diagonally.
3. Lock the nut and perform the cut following
procedure for a straight cut.
ANGLED OR 45 DEGREE CUTS
1. Loosen the two knobs at either end of the
bridge (Fig 11)
.
FIGURE 11
2. Tilt bridge to the desired angle up to 45
degrees. Tighten knobs at either end of bridge,
and proceed with cutting tile following same
procedure as listed in the “straight cut”
section.
CHANGING THE BLADE
DISCONNECT THE POWER
SUPPLY BEFORE MAkING ADJUSTMENTS,
MAINTENANCE, CLEANING OR REPLACING THE
BLADE!
1. CHOICE OF THE SAW BLADE. Use 8 inch
continuous rim, segmented, or turbo blades
with a 5/8 inch arbor.
2. REPLACING THE SAW BLADE
A. Loosen the blade guard thumb screw
(Fig 12).
FIGURE 12
C. Use the hexagonal wrench to hold the
blade nut and use the spanner wrench
provided to hold the shaft. Loosen the nut
turning clockwise as in (Fig 13).
D. Ensure that the shaft and flanges are
clean. Mount blade back on to shaft
ensuring that the directional arrow on the
blade is rotating towards the material to
be cut.
E. Insert flange and lock nut. Tighten
counterclockwise.
FIGURE 13
Loading ...
Loading ...
Loading ...