Loading ...
Loading ...
Loading ...
– 10 –
WHAT TO DO WHEN THE ALIGNMENT
IS OFF ON THE BRIDGE SAW:
The 709-3932 Masterforce 8 inch Bridge Saw
motor or bridge does not need to be squared up
or aligned, since the bridge does not allow the
saw motor to move. When it appears that the saw
is out of alignment, it is the rip fence that needs to
be squared up.
Tools needed:
• 24 inch Framing Square
• Phillips Screw Driver
• ¼ inch Nut Driver or Pliers
The following steps should be used to align the
rip fence for the Bridge Saw:
1. Pull the power unit towards you and lock in
place with the transport screw.
2. Once the power unit is secured, place the
Framing square firmly against the blade on the
left side of the cutting surface. The square
must be flush with the blade. (See Image A).
IMAGE A IMAGE B
3. Slide the square into the rip fence, making sure
the square stays firmly against the blade. Look
for a gap between the square and the rip
fence. If there is a gap, adjustments will be
necessary. (See Image B)
4. To adjust the gap, first remove the Angle cutting
guide. This will expose two screws in the
aluminum track. Loosen both screws in the
extruded aluminum bar. (See Image C & D)
IMAGE C
IMAGE D
Rip
Fence
Gap
Right
Rip Fence
Left
Rip Fence
Loading ...
Loading ...
Loading ...