Loading ...
Loading ...
Loading ...
Troubleshooting
Operation 5
For parts or assistance, call Simer Customer Service at 800-468-7867
Risk of electric shock. Can shock, burn or kill. Unplug pump from power receptacle
before working on pump.
Operation
Risk of electric shock. Can shock,
burn or kill. Do not touch sump pump, pump
motor, water, or discharge piping when pump is
connected to electrical power. Always disconnect
pump cord (power) before handling.
1. Plug this unit into a 115V outlet, on an indi-
vidual branch circuit, with a Class A, 15 amp
GFCI (Ground Fault Circuit Interrupter). Consult
your local electrician for information and avail-
ability.
2. Fill sump pit with water, pump will start auto-
matically when lower rod stop actuates switch
lever arm. When upper rod stop actuates
switch lever arm, pump will stop.
NOTICE Do not allow pump to run dry.
Risk of electric shock. Can shock,
burn or kill. Before attempting to service,
always disconnect power from unit.
3. The motor is equipped with an automatic reset
thermal protector to protect unit from overheat-
ing. When motor has cooled sufficiently, switch
will reset automatically and restart motor.
Repeated tripping could be caused by low volt-
age, long extension cords, clogged impeller,
very low head or lift, etc. Cycling of protector
will cause eventual motor burnout.
Symptom Possible Cause(s) Corrective Action
Motor will not Run
No electrical power
Check fuse, circuit breaker, power cord and and
electrical outlet.
Low line voltage
If voltage wiring under recommended minimum, check
size of wiring from main source. If OK, contact Electric
Company or local Hydro cuthority.
Faulty automatic switch Operate switch manually and replace if inoperative.
Float or float rod stuck
Check to see float is not rubbing sump wall or float rod
rubbing or stuck against sump cover.
Watterlogged float Replace float if filled with water.
Motor overload tripped
If pump has been running and stops before sump is
emptied, automatic overload may have been tripped.
Check inlet screen to be sure impeller is not jammed. If
so, free impeller of obstruction.
Electrical malfunction
Check power cord, automatic switch and motor.
Replace faulty parts as needed.
Motor runs but pump will
not pump
Inlet clogged Check inlet and clean if needed.
Discharge line plugged Clear discharge line and check valve for obstruction.
Low line voltage
Refer to Corrective Action on low voltage in above
section.
Pump airlocked
Drill a 1/8” (3.2mm) hole in discharge pipe just above
pump body but below the check valve.
Broken impeller or shaft Replace impeller or shaft as needed.
Pump starts and stops too often
Improper positioning of float rod stop Lower float rod stop.
Faulty automatic switch Replace automatic switch.
Pump is noisy
Improper installation Refer to No. 5 in Installtion Instructions
Noisy motor Replace pump.
Pump will not stop running
Debris around float or float rod stuck
Remove debris from sump. Check to see float is not
rubbing sump wall or float rod rubbing or stuck against
sump cover.
Faulty automatic switch Replace switch.
Motor defective Replace pump.
Loading ...
Loading ...
Loading ...